Touch Pad

I replaced the part by popping off the plastic frame and removing several easily-accessable screws. Three small electrical plugs had to be popped off too. It was a very simple repair. The Sears guy wanted $395 total for the repair, and I did it myself for the price of the part on this site (around $90). Very pleased! Read more

Replaced solonoid. Video was very helpful. Parts came in the time frame given when I ordered the part. (1.7 days). Without the video I would have called a repairman. Thanks . Read more

So I ordered the face plate and other parts that went with it and fixed it myself. The repair man wanted around $600 to do it. I believe kt cost around $160 to fix it myself. Read more

Replace dispenser micro switch. Also replaced broken faceplate and rusty screws. Appliance parts Pro YouTube video was helpful in diagnosis and disassembly. Parts arrived quickly. Read more

So I ordered the face plate and other parts that went with it and fixed it myself. The repair man wanted around $600 to do it. I believe kt cost around $160 to fix it myself. Read more

I ordered the part from you and removed the damaged board and replaced it with the new board. It now works perfectly. I took all of about ten minutes. Thanks so much! Read more

After viewing your video the job went as planned and took maybe 20 minutes. Read more

Disconnect the power to the fridge. First remove the control panel by removing the one screw underneath and then insert a screwdriver into the small square hole underneath in order to pull the lower left of the control panel towards you. You are pulling against a plastic clip and you need to pull fairly hard. Once the lower left clip is free the other three come unclipped fairly easily. At this point it will make life easier if you unclip the wiring connector from the control panel and put it... Read more

1. Purchased a new Facade. The removal of the old one was relatively easy except that the two screws that hold it in place (behind the spill tray) were rusted (they should have used stainless steel ones) one came out with a vise grip but on the other I had to buy an "Easy Out" tool from Home Depot, once out the unit drops down. Had my wife hold the new unit, swiped the wires from old to new, removed the control board from the old one and installed it on the new one with one screw and cleaned... Read more

Using the model number of the frig, I located the part (Interface Dispenser Asm) on the AppliancePartsPros.com. After reading the Q&A section for hints on how to change the part and looking at a couple of YouTube videos, it seemed that I was up to the task. I placed the order for the part and was pleasantly surprised that it arrived in a couple of days. Armed with a flat blade screwdriver and an old credit card, it took me about 15 minutes to first remove the bezel around the ice dispenser... Read more

Replaced with ordered cover and new screws. Cover was a perfect replacement for original. Replacement took less than 15 minutes to complete. Read more

Removed old label, took the glue residue off, wiped it down with rubbing alcohol then attached the new label on to the fridge. Read more

I googled my refrigerator model number and the problem. It brought me to a message board with a thread about my exact problem. A seasoned tech answered the persons question about their ice not dispensing by stating they needed to replace the module-dispenser because of a faulty switch. He also stated he didn't think the switch was a part that could be ordered. He suggested I order from you and stated if it did not fix the problem, I could easily return it for a full refund but I would have to... Read more

Replaced Keyboard Control Touch Panel and Refrigerator Thermistor. Video was very helpful on how to change. Read more