Frigidaire Parts

• Door won't open or close

Ordered a new handle. Unscrewed two screws took the old handle off and put the new one on put the screws back in. It works great!! Read more

• Lid or door will not open
• Won't start
• Lid or door won't close

Just removed the old and put on the new,simple.On this Fridgidare washer you should lift the door as you close it which should make the striker last.. Read more

• Will not drain

After inspecting screen and drain hose with no obvious cause, replaced drain pump. Removal of the pump was very straight forward. 3 screws, 2 electric connections, and 1 hose clamp was all that was needed. Read more

Replace the sprayer in the middle of the dishwasher, the problem was the grommet on the back of it but it's not available individually. Read more

• Freezer not defrosting
• Fridge too warm
• Freezer section too warm

This was a 2000 model so rather than just replace the defrost timer which was visibly burnt on the terminals, we just did everything. The cold control, defrost timer, thermostat, defrost heater and the compressor capacitor were all replaced. I had the same issue on my older unit and tore it apart replacing one item at a time over a three month period so on an older one i suggest do it all while it is apart. Read more

I have used this freezer for ~ 10 years with no problems. We have noticed that frost started forming inside the freezer, so after research, the first step was to replace the gasket around the door. I ordered the part and replaced it, which took about 45 minutes. To replace, I would recommend unscrewing the screws around the existing gasket BUT DO NOT REMOVE THE SCREWS as that will take extra work. Just unscrew, and make sure the old gasket comes out of the track easily. To re-install,... Read more

Change filter Read more

• Not dispensing water
• Leaking
• Ice maker not making ice

This was a tough fix because there were two causes to my problem - a stuck water valve and a bad ice maker. I first replaced the water valve, but that did not resolve the problem. Tested existing water valve and found that the valves were working properly. Returned the water valve - easy RMA process and no issues. Replaced the ice maker and problem solved. Read more

• Won't start
• Too warm
• Fridge too warm
• Freezer section too warm

In short - I replaced the evaporator fan motor and the evaporator fan blade. The Appliance Parts Pros website was extremely helpful to me. Here's how. 1. The site helped me identify that even though my Freezer says it's a Frigidaire, it's actually an Electrolux. 2. The site identified the potential screech causing parts. (I didn't take a chance, I bought all three) It was a worthwhile investment. My freezer is 20 years old so it deserved some help. 3. The site provided guidance videos (not... Read more

• Ice maker dispenses too little ice
• Touchpad does not respond
• Leaking

Replaced ice maker Read more

I ran a diagnostics check on the washing machine and came up with the error code E47 -Board thinks the door PTC circuit is open in spin. The washer thought the door was open and would not finish the spin. I was left with a washer full of very wet clothes. This repair was SO extremely easy. I only needed to uses a pair of needle nose pliers and a screw driver. It took less than 10 minutes, start to finish. Now the new door lock assembly registers correctly and my clothes are completely... Read more

Ordered left and right side supports and they arrived in two days! It took me longer to get stuff out of the way in the fridge so I could take the shelf out than it did to actually swap out the side supports. Parts fit perfectly and quick easy repair. Read more

• Element will not heat

Replaced all four element switches. Switches arrived within two days of ordering. That's about normal for AppliancePartsPros. They were the correct ones; not generic, and fit the original control knobs perfectly. This kind of service is what I'm used to from ApplicanePartsPros. Read more

Pulled the old ones off, pushed the new ones on. Read more

Very easy Read more

Disassembled dryer. Installed new belt, drum rollers, idler arm and blower. Read more