General Electric Cap Or Cover

This ice maker receptacle cover protects the electrical connector and housing where the ice maker plugs into the refrigerator, helping keep the connection clean and secure for reliable ice maker operation. What it does

• Covers and shields the ice maker electrical receptacle from debris and moisture
• Helps prevent accidental contact with the connector for improved safety
• Maintains proper alignment and fit of the ice maker plug to reduce connector strain
• Commonly replaced when cracked, broken, or missing, which can expose the receptacle

• Disconnect power to the appliance before inspecting or replacing the cover
• Usually snaps or screws into place; remove adjacent trim or ice bin for access if needed
• Handle gently to avoid damaging surrounding plastic housings or the connector
• If electrical damage or corrosion is present, inspect wiring and connector; replace damaged parts before reassembly

Refrigerator door hinge cover that installs over the top hinge assembly. Replace this plastic cap if it's cracked, broken, or missing to restore appearance.

White plastic hinge cover for refrigerator freezer door. Replaces cracked, broken, or missing covers. Snaps onto hinge assembly for a clean finish.

White plastic hinge cover for refrigerator fresh food compartment. Replaces cracked, broken, or missing hinge caps. Snaps onto door hinge.

This outer corner cap replaces a broken or missing plastic trim piece on the appliance door, restoring a finished look and protecting the edge from further damage. Designed as a direct-fit cosmetic/trim component. What it does:

• Covers and protects the appliance door corner from chips, dings, and everyday wear.
• Restores a flush, finished appearance where the original corner trim is cracked or missing.
• Helps prevent moisture and debris from collecting in the corner joint.
• Common symptom: visible cracked, loose, or missing corner trim on the door edge.

• High-level replacement — usually snaps into place or secures with a small screw; remove any old, damaged trim before installing.
• Disconnect power or follow manufacturer safety guidance if working near electrical components.
• Use a non-marring tool to avoid scratching adjacent surfaces when prying out the old cap.
• Warming the new cap slightly can ease installation; do not force parts.