General Electric Heating Element

This heater assembly replaces the heating element that warms the dryer drum so clothes dry efficiently. Restores normal drying performance when the original element is broken, burned, or open. What it does

• Provides the electric heat source that raises drum temperature for drying.
• Heats air circulated through the drum so fabrics dry in expected cycles.
• Commonly replaces units that are visibly damaged, open on a continuity test, or causing no/low heat and long dry times.
• Works with the dryer's thermostats and cycling controls to maintain safe operating temperature.

• Disconnect power to the dryer before starting any repair to avoid shock or injury.
• Handle the heating element carefully—coils and ceramic mounts can be fragile.
• Check associated thermostats and fuses if symptoms persist after installing the heater.

This heat sink helps remove excess heat from the appliance control area to protect electronic components and improve long-term reliability. It's a direct-replacement part designed to match the original form and mounting. What it does:

• Conducts and disperses heat away from the control board and sensitive electronics
• Helps prevent overheating symptoms such as intermittent control failures or component stress
• Supports stable operation during high-heat cycles or heavy use
• Fits the original mounting points to maintain proper airflow and clearance

• One heat sink

• Disconnect power before starting any repair to avoid electrical shock
• Handle carefully — edges may be sharp and electronic components can be static-sensitive
• Verify correct placement and secure all fasteners; follow the appliance service manual for routing and orientation

This heater/guard assembly protects and supports the dryer's heating element while helping direct airflow for efficient drying. It replaces a damaged or corroded housing to restore safe, reliable heating performance. What it does

• Shields the heating element from contact and debris to reduce fire and damage risk
• Keeps the element properly positioned for consistent heating
• Helps channel airflow through the heating chamber for efficient operation
• Common replacement when you see burnt wiring, visible housing damage, or intermittent/no heat

• One heater/guard assembly

• Always disconnect power (unplug or shut off breaker) before servicing
• Allow the dryer to cool completely; metal edges may be sharp
• Removal typically requires access to the rear or cabinet and basic hand tools; follow your model's service manual

This heater assembly supplies the heat source for a clothes dryer, restoring normal drying performance by replacing a worn or failed heating component. Designed for easy swap-in replacement where compatible. What it does:

• Generates the hot air needed to evaporate moisture from laundry
• Restores proper drying when a dryer produces little or no heat
• Helps reduce extended dry cycles caused by a failed heating element
• Works with the dryer's existing blower and controls to maintain temperature

• Disconnect power to the appliance before beginning service; for gas dryers also shut off the gas supply
• Handle the heater element and terminals carefully to avoid damage and ensure proper connections
• Confirm fit and wiring match your dryer before final reassembly;