General Electric Panel Parts

This white access panel covers and protects internal components while keeping the appliance looking finished. It provides easy service access for repairs and helps prevent dust, pests and accidental contact with controls. What it does

• Covers service areas so wires, valves and controls stay protected from debris and contact
• Lets technicians reach components for diagnostics and repairs without removing larger panels
• Restores the appliance's exterior appearance when original panel is cracked, warped or missing
• Helps reduce drafts or light entering the cabinet around service openings

• One white access panel

• Disconnect power to the appliance before beginning work to avoid shock or injury
• Typically secured with screws or clips; retain hardware from the original part if reusing
• Handle edges carefully to avoid scratching the finish; align tabs or screw holes before fastening

This black toe kick replaces the lower front trim panel on compatible appliances to restore appearance and protect the cabinet base from scuffs and debris. It provides a clean, finished look at the appliance base. What it does:

• Covers and protects the appliance baseboard area from scuffs, dust, and spills
• Restores a finished appearance when the original toe kick is cracked, bent, or missing
• Helps conceal wiring and under-cabinet gaps for a neater installation
• Fits where the factory toe kick trim is worn or cosmetically damaged

• High-level replacement; remove lower access panels or clips to access mounting points
• Use basic hand tools; support the trim during removal to avoid damaging adjacent panels
• Keep screws/clips from the original part for reinstallation
• Disconnect power to the appliance only to access the toe kick area; follow all safety precautions

This long front panel replaces a damaged or worn control-area panel to restore the range's appearance and provide a secure mounting surface for control components. It fits the long control area used on select GE ranges. What it does:

• Replaces cracked, dented or heavily scratched front/control-area panels to improve appearance
• Provides the mounting surface and alignment for control switches and trim
• Helps keep internal components shielded from spills and debris near the controls
• Restores a flush fit where the original panel was warped or bent

• Disconnect power to the appliance (unplug or switch off breaker) before starting work
• Remove control knobs and any trim pieces to access mounting screws; keep original fasteners for reassembly
• Handle the panel carefully to avoid cuts from sharp edges and to prevent cosmetic damage
• Take care when disconnecting and reconnecting wiring;

This front panel assembly replaces a damaged or worn console bezel to restore the appliance's appearance and provide a secure mounting surface for the control components. It helps protect the controls and keeps the front of the unit looking finished. What it does:

• Replaces a cracked, bent, or cosmetically damaged front console bezel
• Provides mounting and protection for buttons, switches, and the display area
• Restores a flush, finished appearance to the appliance front
• Helps ensure controls remain accessible and securely seated

• One front panel assembly

• Disconnect power (unplug or shut off breaker) before starting work
• Handle the panel carefully to avoid scratching or chipping finished surfaces
• Removal/installation requires basic hand tools; panels may secure with screws and clips
• Note connector/ribbon positions and reconnect carefully