General Electric Panel Parts

This inner door panel replaces a damaged or worn internal door surface to restore a clean, secure oven/microwave door interior and support proper window assembly alignment. It fits behind the outer door and holds the inner glass in place. What it does:

• Replaces cracked, chipped, or warped inner door surface that can trap debris or affect door closure
• Restores the inner layer that helps keep the door assembly aligned and stable
• Reduces rattling or vibration caused by a loose or broken inner panel
• Helps maintain a clean interior appearance by covering internal components

• Disconnect power (and gas, if applicable) and allow the appliance to cool before starting
• Handle the panel carefully—sharp edges or glass may be exposed; wear gloves and eye protection
• Keep all original fasteners and note screw locations
• After installation, confirm the door closes and seals correctly and test the appliance on a short cycle

This rear panel is the replacement cabinet back panel that restores the appliance's exterior enclosure and supports internal components. It provides a clean, secure rear surface and helps protect internal wiring and parts from damage. What it does

• Replaces a dented, rusted, or damaged rear cabinet panel to restore proper enclosure and airflow
• Shields internal components and wiring from dust, debris, and accidental contact
• Helps maintain proper venting clearance and appliance stability when mounted correctly
• Prevents sharp edges and gaps that can cause injury or allow pests into the cabinet area

• Disconnect power (and gas if applicable) before servicing; ensure appliance is fully de-energized
• Remove rear access screws and any attached components carefully to avoid damage
• Align panel, secure with manufacturer-specified fasteners, and verify there are no gaps or pinched wires

This kick panel assembly replaces the bottom toe grille on compatible refrigerators to restore the finished look and help direct airflow. It refits under the cabinet for a clean, factory appearance. What it does:

• Covers the refrigerator's lower front opening for a finished exterior and to protect internal components
• Directs air flow at the base to support proper ventilation
• Helps prevent debris from entering the lower service area
• Restores missing or damaged trim that can affect appearance and clearance

• Basic removal of the old panel and fastening of the new panel with existing screws/clips; keep fasteners for reuse if undamaged
• Handle gently to avoid scratching painted or plastic surfaces during install
• Disconnect power only if required to access lower service area; follow appliance safety guidelines

This finished toe kick panel replaces the lower front trim on compatible GE washers and dryers to restore appearance and protect the cabinet base. It provides a clean, finished look and covers the gap between the appliance and the floor. What it does:

• Replaces a damaged, scratched, or bent toe kick to restore the appliance's exterior finish
• Covers and protects the cabinet base from dust, debris, and foot traffic
• Helps maintain a finished, factory appearance after repairs or cabinet work
• Fits where a finished front toe panel is required for proper cosmetic restoration

• Intended for cosmetic replacement; fit to your exact model before installation
• Remove power (unplug or shut off breaker) before accessing panels near controls; follow all safety precautions
• May require removal of lower access panels or screws; retain original fasteners unless replacements are provided