General Electric Plug Or Insert

This plug button is a small snap-in cap used on refrigerators to cover exposed holes on door handles, liners, or trim. It restores a clean, finished look while helping keep dust and moisture out of the cabinet.

• Snaps into a screw or access hole on a handle, liner, or trim panel
• Covers fasteners and gaps for a clean, finished appearance
• Helps block dirt and moisture from open holes
• Typical symptoms: missing cap, broken or loose plug, visible screw hole or cosmetic gap

• Unplug the appliance before servicing and use caution around sharp edges
• Align the plug with the hole and press straight in by hand until fully seated and flush
• For handle screw holes, tighten fasteners first, then install the cap
• Avoid using metal tools on finished surfaces to prevent scratches

Seals the unused drum light opening in your dryer cabinet. Replace if missing, cracked, or brittle to contain lint and protect internal components.

Push-in plug button for top-load washers. Snaps into trim openings to cover unused holes and restore a clean finish. Replace if cracked or missing.

Small push-in plug button that covers unused mounting holes on your refrigerator for a clean finish. Replace missing, cracked, or damaged buttons.

Replace missing or broken water filter hole plug insert in your refrigerator. Covers the filter cavity opening when no filter is installed.

White 1/4-inch plug button insert for chest and freestanding freezers. Replaces cracked, broken, or missing decorative plugs in cabinet holes.

Replacement plug cover for your refrigerator. Snaps into place to conceal openings or unused ports. Order a new one if yours is cracked or missing.

Replaces a cracked, broken, or missing refrigerator plug button. This cosmetic insert installs in cabinet holes to cover openings and finish edges.

This push-button plug insulates and seals a control panel push-button, helping keep the button stable and protecting the switch from moisture and debris. Fits where a small plastic button bushing or insulator is needed on the control panel. What it does:

• Provides an insulating bushing for a control panel push-button or switch
• Helps hold the button aligned and reduces wobble or uneven operation
• Shields the switch contacts from moisture and dirt that can cause intermittent operation
• Commonly replaced when the button is loose, damaged, cracked, or missing

• Disconnect power to the appliance before removing the control panel or working near electrical components
• Remove the control panel or trim; use appropriate tools to avoid cracking surrounding plastic
• Install the plug gently; do not force or use excessive heat

Refrigerator plug button that installs in the cabinet or liner. Replace this insert if the original is cracked, broken, missing, or worn from use.

Outer drain plug for freezer defrost drain system. Replaces cracked, broken, or missing plugs that cause leaks. Installs at base of freezer.

Replacement rail front plug kit for refrigerator shelves. Installs on the front of shelf rails to secure and finish the assembly. Order if cracked or missing.

Recessed plug insert for refrigerator cabinet holes. Replaces broken, cracked, or missing plastic plugs that cover mounting or adjustment holes.