Hose Or Tube

Replaced the drain pump and the drain hose (since I was replacing the drain pump). The new drain pump seems to pump out the water more forcefully than the one replaced. Have not received a LD code during the wash cycle since the replacement was installed. Read more

Our washing machine door boot seal was getting moldy and causing odor problems. Cleaning tablets and bleach weren't helping so it was time to be replaced. While I had the top and front off I changed all the hoses that could be collecting soap scum and mold, all other wetted parts were removed and washed. The video on the door boot seal, and inlet valve assembly were extremely helpful in understanding how these parts are removed and reassembled. Although the door boot seal is the most visible... Read more

• Leaking

Replaced both Read more

With new hose Read more

• Leaking

I replaced the pump drain assembly. The flapper valve was included in the assembly, so I did not need to order that. On previous repairs, the old drain hose was tricky to reinstall, so I replaced it and the hose clamp.The silverware basket had holes in the bottom and required replacement. I had some broken tine clips. Read more

Replaced filter housing, and both water tubes Read more

I replaced the water level sensor on the side of the dishwasher. Had to completely take out dishwasher and set on its side. Removed three hose clamps and three electrical disconnects. I have hard water and it looked like the float inside of the sensor wasn't moving properly. Read more

I found the condensing fan motor would not turn with power applied. I also found a drain tube cracked and breaking. I had to use a snub nose screwdriver to remove and replace condensing fan motor. The power wires were simply a snap on. The new drain tube just slipped on. Thanks for the speedy delivery! Stephanie Hobbs Read more

• Leaking

Thought leak was coming from icemaker but refrigerator was making ice just fine. had puddle on floor just below freezer door. upon closer inspection realized leak was coming from drain line. there were 2 pieces of tubing and the connector. leak was coming from where tubing goes into connector. wanted to replace it. didn't know what it was called. did live chat with someone I think was named James. he sent me diagrams and I could identify the part. once identified I ordered it. boom.... Read more

Replaced flow meter and control valve Read more

Replaced hoses. They were not an exact replacement but they did end up working with the purchase of one additional fitting (5/16 x 1/4 coupler) Read more

First of you need to remove front panel of the washer, using a putty knife push the tabs between the top of the machine and the front panel. Once front panel is exposed drain hose is connected to pump which is in the front of the machine,very easy to access with the front off. Remove old hose with pliers and discard ,run new hose thru outlet on the back of the machine and secure new hose to drain and secure hose to the machine, reinstall front panel of washer and that's it Read more

Replaced entire water supply system: ice maker water supply tube, water tank, solenoid, filter and filter head, water supply tubing. Read more

I replaced the drain pump and hose which had a flapper valve that wasn’t sealing properly. Easy repair. Took about 15 minutes total and my washing machine is Soooo much quieter!!! Read more

Used vids on youtube for steps on how to disassemble and install the pump; search "Bosch dishwasher circulation pump replacement". Also on AppliancePartsPro forums, a poster put up the Bosch "Dishwasher Service Training Manual" in .pdf. Search "Bosch dishwasher low pressure" on the forum. It's one of the post with the longest thread. Six pointers. 1. In another forum post, the poster noted that some hoses were brittle with age - and cracked when reinstalling. I had same issue (my washer is... Read more