Need Help?
Call
Replaces a broken or worn refrigerator door stopper that cushions the door in the open position. Installs at the top of the door frame with screws.
I ordered the parts and they arrived in 2 days. While the parts were in transit, I watched the video concerning replacing the gasket holder. WHAT A LIFE-SAVER! From start to finish took less than 60 minutes!!! Note: I did take some water and ran it down the channel where the gasket goes to make it easier to slide onto the gasket. Read more
Connects water tubing inside your refrigerator to supply the ice maker and water dispenser. Replace if cracked, leaking, or unable to hold tubing securely.
This is a polyethylene (PE) plastic tube with a 1/4" outer diameter used to carry water within the refrigerator, typically connecting the water inlet valve to the ice maker or water dispenser. It provides a flexible, food-safe pathway for water flow. Replace this tubing if you notice leaks, cracks, kinks, or reduced water flow to the ice maker or dispenser.
Replaced 3 water lines on rear of refrigerator. Read more
Front-load washer door boot seal prevents leaks between drum and cabinet. Replace if torn, cracked, or moldy to stop water damage. Confirm fit with model.
Replace the boot seal assembly Read more
Directs water from inlet valve to detergent dispenser in LG washers. Replace if hose is cracked, leaking, won't stay attached, or damaged from wear.
I figured after 10.5 years that it might be time to replace the dispenser hoses because I was noticing black stuff in the dispenser trays. I replaced two or the four hoses and clamps on the far left side and for good measure the hot water inlet valve. The inlet valve was okay but the screen had all kinds of crap in there that I couldn't clean out so now I have an extra solenoid just in case one of the others fails. While I was at it I removed the dispenser and cleaned the calcium build up on... Read more
The Pump Hose is an OEM replacement part for LG washing machines. It is a flexible tube that connects the pump assembly to the internal tub and spins through the detergent dispenser area. The pump hose is responsible for circulating and removing water during the wash and rinse cycles.
Symptoms of a bad pump hose include:
Causes of failure can be cracks or splits developing in the tubing from repeated bending and flexing over time, or blockages restricting water flow.
It is also compatible with some Kenmore models.
REMOVED BACK PANEL, USED PLYERS TO REMOVE CLAMP, PULLED OLD HOSE OFF, REVERSED PROCEDURE TO INSTALL NEW HOSE. TOTAL TIME ABOUT 10 MINUTES. Read more
Replaces cracked, worn, or broken turntable support ring in your microwave. Supports the glass tray and engages the rotating coupler mechanism.
Replaced the part in a few seconds. Working fine now. Read more
Removes contaminants for clean, fresh-tasting water and ice. Replace every 6 months or 200 gallons to maintain water quality. Verify fit with your model.
Took the old one off and put the new one on Read more
The Ice Cube Tray is an OEM part for LG refrigerators. It is located in the freezer section of the refrigerator and provides a designated space for freezing water into ice cubes. It is designed with individual compartments to form ice cubes in a specific shape and size.
Causes of a faulty ice cube tray can include regular wear and tear, physical damage, or improper handling. These factors can result in issues such as the tray cracking or breaking, difficulty in removing ice cubes, or improper freezing of the cubes.
Symptoms of a bad ice cube tray may include:
This OEM LG part can also be used on Kenmore/Sears appliances.
It was a snap. All I had to do was unsnap one end of where the ice tray attached to the ice maker and fit the tray into the two sides and then resnap the end back onto the icemaker. Very easy. Read more
Ice maker stopped making ice or water dispenser not working? This water inlet valve controls water flow to both. Common fix for sudden water issues.
The Door Hinge is an OEM part for LG dryers. This hinge supports the dryer door, allowing it to open and close smoothly and securely. It ensures that the door stays aligned and functions properly, providing reliable access to the dryer drum for loading and unloading clothes.
Causes of a bad door hinge can include frequent use leading to wear and tear, physical damage from forceful opening or closing, and rust or corrosion due to exposure to moisture.
Symptoms of a bad door hinge include:
This OEM LG part is also compatible with some Kenmore models.
This part was the perfect fix for my broken door hinge on my LG front loading dryer. I watched a video on YouTube of a hinge replacement of a similar front loading Samsung dryer. I needed a little help from my son holding the door glass and plastic in place while re-attaching the door to the hinge, but it was an easy repair. Read more
Replacement suspension spring for washer tub support. Installs between cabinet and tub to absorb vibration. Replace if broken, stretched, or missing.
Our 10-year-old LG WM2487HWMA front load washer had gradually developed multiple problems. It sounded like a jet engine during high speed spin, both the drain pump and circulation pumps were noisy, it would not drain properly (water was coming in during spin cycle), no water was spraying out at the top of the door into the drum like it is supposed to when the circulation pump was running. It's amazing we had still been able to wash clothes at all! With the help of the excellent... Read more
Fix a loose or missing fabric softener cap that won't stay in place or causes drawer issues. Simple snap-in replacement restores proper dispensing.
Took top off and did a line at a time Read more
The Rear Evaporator Motor Grommet is an OEM part for LG refrigerators. It's designed to secure and cushion the evaporator motor, ensuring it remains in place and operates quietly. This grommet plays a crucial role in minimizing vibrations and noise from the motor, which can otherwise lead to a disruptive refrigerator operation.
Causes of a bad Rear Evaporator Motor Grommet can result from deterioration due to cooling and thawing cycles in the refrigerator. Physical damage during cleaning or servicing may cause a loose motor fit.
Symptoms of a malfunctioning Rear Evaporator Motor Grommet include:
Ordered parts, removed top tray in freezer, popped the back inside freezer panel out removed and replaced fan, dampers and fan housing. Took about 15 minutes. Read more
Fix IE error codes and water leaks with this dishwasher water inlet valve. Moderate difficulty repair requiring dishwasher removal and front access.
The insulation in my old Ohio house is terrible, and the Valve Assy, Inlet part under my dishwasher must have froze and burst when the temperature outside got below 0. I ordered this part here, and literally got it the next day. Awesome. The how-to video on the site was perfect. Not only did I replace the part in about an hour, but I saved ~$200 by canceling my LG service repair appointment. Read more
Fix loud banging, grinding noise, or poor drying performance with a new dryer blower wheel. Restores proper airflow through drum and exhaust vent.
I replaced the dryer motor. I followed the repair video on the Appliance Parts Pro site, with a few modifications to the procedure. I loosened the control panel and flipped it forward to improve access to the wiring connectors. I also loosened the front panel and tipped it forward before disconnecting the door switch as there wasn't enough space to disconnect the switch otherwise. Removal of the blower assembly required the use of penetrating lubricant as the assembly was stuck on the motor... Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.