Lg Parts

The left hinge works on the right side as well as the left. All you have to do is unscrew the little plastic post and move it to the other hole. So even though the web might say that the left hinge assembly is not compatible with your fridge, or that the right hinge assembly is no longer available, it will still work. The door stopper assembly worked just fine. All you have to do is screw it in to the bottom of the door. You will have to disassemble the top hinge (on top of the fridge) in... Read more

Replaced the Thermistor Assembly and also picked up Overload Protection circuit per the comments posted by the "experts" on the web site. Both parts cheap enough. I ordered parts at 3:30 in the afternoon and they showed up the next morning from half way across the country. Outstanding service. It also fixed the 9 year old refrigerator. Replacing the parts took about a half hour most of which was moving the unit from the wall and removing the panel to get at the parts. Read more

Replaced filter with plug. Read more

I bought a new cooling motor and blade and installed it, everything seems to be working fine now, did not take that long to fix, maybe about 30 minutes, the longest part was trying to get the old fan off the old motor, finally had to cut it off with bolt cutters, I have a 12 year old LG Refrigerator 26930 double door, if you are handy its not that hard. I had to remove a couple parts in front of the motor to get to it, but very easy. Better than buying a new refrigerator...:). I replaced the... Read more

• Frost buildup
• Doesn't shut off
• Fridge too warm

I removed the defrost sensor assembly, installed a new one, it worked. Because of a shipping problem with FEDEX, Appliancepartspros resent the parts not once but twice. Needless to say, they are my go-to source for parts from now on. Read more

After watching repair videos, I decided I could order the parts needed and do it myself for less than a service call, not to mention the additional cost for parts markup and installation that a service technician would charge. I am very pleased that I did. I ordered the start relay, overload and capacitor with some help from Ilya at customer service to make sure I was getting the correct replacements. Installation was easy. The hardest thing was contorting my body into a position where I could... Read more

I ordered the parts and they arrived in 2 days. While the parts were in transit, I watched the video concerning replacing the gasket holder. WHAT A LIFE-SAVER! From start to finish took less than 60 minutes!!! Note: I did take some water and ran it down the channel where the gasket goes to make it easier to slide onto the gasket. Read more

I figured after 10.5 years that it might be time to replace the dispenser hoses because I was noticing black stuff in the dispenser trays. I replaced two or the four hoses and clamps on the far left side and for good measure the hot water inlet valve. The inlet valve was okay but the screen had all kinds of crap in there that I couldn't clean out so now I have an extra solenoid just in case one of the others fails. While I was at it I removed the dispenser and cleaned the calcium build up on... Read more

Thanks to Appliance Parts Pros, who took the time and made the effort, they found me a replacement part for my dishwasher. Read more

I also noticed one of the two water recirculation outlets near the front door was no longer spraying water. When I took it all apart, I found that these two tub water recirculation outlets are both connected to the pump.. one was clogged. The impeller on the drain pump was no longer spinning with the motor.. looks like it was worn on the inside.. when I took the pump apart it was full of scale. I could have just ordered the motor...but I figured I would replace the entire assembly as I also... Read more

Replaced the part in a few seconds. Working fine now. Read more

• Doesn't shut off

Looked online. Others said to start with the thermostat because its cheap and easy to fix, so I did. The thermostat is located at the rear of the oven on the back. You need to remove a total of 3 panels to get to it. Do not confuse it with the thermal sensor at the rear of the oven on top. My thermostat was clearly deformed, and I had never run a self clean like other with testify to. Simply replace it - easy. Oven worked like new. Read more

I ordered the parts and they arrived in 2 days. While the parts were in transit, I watched the video concerning replacing the gasket holder. WHAT A LIFE-SAVER! From start to finish took less than 60 minutes!!! Note: I did take some water and ran it down the channel where the gasket goes to make it easier to slide onto the gasket. Read more

Used video and took apart dru, this was extremely helpful. I bypassed the belt and door switch. Tested gas valves (gas disconnected) with multimeter. Found that the igniter worked the first gas valve, but the second gas valve would not open and the igniter would stay on. Found a flow chart online that shows the flame detect turns on causing the gas to turn on and shuts off the igniter. I replaced it and tested again. Igniter turns on, shuts off, then power to the second gas valve turns... Read more

REMOVED BACK PANEL, USED PLYERS TO REMOVE CLAMP, PULLED OLD HOSE OFF, REVERSED PROCEDURE TO INSTALL NEW HOSE. TOTAL TIME ABOUT 10 MINUTES. Read more