This inlet hose routes incoming water from the washer's fill valve into the machine to support proper filling. Replace a cracked or leaking hose to stop drips, prevent water damage, and restore reliable fill performance.
- Directs incoming water from the fill valve to the dispenser/tub during wash cycles
- Maintains a sealed path to prevent internal or external leaks
- Helps the washer reach proper fill levels and timing
- Common symptoms of failure: water on the floor, leaks during fill, visible cracks or bulges, long/no fill or IE error
What's included: 1 inlet hose Install notes:
- Unplug the washer and turn off both hot and cold water supplies
- Keep towels or a pan handy; relieve residual water pressure before disconnecting
- Note the original routing; fully seat the hose on fittings and secure with existing clamps
- Restore water and power, then run a quick fill to check for leaks
Do-It-Yourself Stories from Customers like You
Little black specks in the dispenser tray calicum build up and rusted clamps on rear of dispenser Paul B. • San Diego , CA • January 30, 2017
I figured after 10.5 years that it might be time to replace the dispenser hoses because I was noticing black stuff in the dispenser trays. I replaced two or the four hoses and clamps on the far left side and for good measure the hot water inlet valve. The inlet valve was okay but the screen had all kinds of crap in there that I couldn't clean out so now I have an extra solenoid just in case one of the others fails. While I was at it I removed the dispenser and cleaned the calcium build up on...
Read more