Lg Parts

We knew at least one door hinge cable assembly or hinge spring was broken (the door started falling down rapidly and became heavy to close) so we ordered two of each since we had read to go ahead and replace the damaged items on both sides. While we were waiting on the order, the other side must have broken-the door became incredibly heavy and instead of falling open, started crashing down unless it was carefully lowered. We feared it would fall on one of our animals and kill them. We did not... Read more

Ordered the plastic glides that connect to the metal rails. Super easy fix! Read more

Replaced lower hinge. It took about 20 min. Read more

Ordered the entire control panel. Took only 30 minutes to replace. Once I received the new part, it was obvious how easy it would be to replace. A thin putty knife and a little care not to damage the surrounding surface was all that was needed. Read more

Looked online at several websites to see if I could figure out the problem Came across AppliancePartsPros video on replacing bearings. Watched it a couple of times and determined (well, guessed) it was the bearings and/or spider. Followed the video (great job by the way) and disassembled the washer. The spider was cracked on one arm so ordered a new one from this site. I also ordered two new bearings and the bearing seal b/c learned from the web and local appliance store that they go bad in 7+... Read more

Replaced defrost sensor in freezer compartment, if you are handy this is a do it yourself job. The cover in the freezer section just pops out not tools needed. You will need a few small zip ties and some cutters to remove the old zip ties. Take a picture were the old sensor was before removing and reinstall in the same place. I used a meter to check continuity of the defrost element and found the element to be ok. I was quoted $85 to have someone come to the house just to check the unit and... Read more

I replaced the dispenser assembly and since this was being replaced, I installed a new drawer and detergent box assembly. Read more

Replaced the existing pump with the new pump. Took about 10 minutes, saved $200 bucks. Read more

I have an LG dryer purchased in 2007. Model: DLE9577SM. It was squeaking at start-up and rumbling a little. Not knowing what parts I would actually need, I ordered rollers with/without assemblies, tensioner pulley-only, new belt. After viewing this video a couple of times, I attacked my machine which is located in the comfort of my garage. Lots of room to spread out. Nice. This disassembly went OK however because, I suspect, my machine is 13 years old, the removal of the control panel was... Read more

Replaced the drain pump and circulating pump units. Read more

• Leaking

Replaced tank assembly. Actually I think the supply hose was originally not fully seated in the tank and I think I could have re-seated it deeper through the gray bushing. When I set the line into the new tank, still leaking. Pulled out supply line and reset using a little more force and line went into the tank. Took the bushing clip off the other tank and used it for the supply line bushing. So far, no leaks. The thing to remember is to push the edges of each hose bushing inward to pull... Read more

Replace thermistor. Explained to home owner either thermistor or compressor since it was running hot but only 10 minutes to change out. Luckily client still has warranty on fridge to replace old compressor and thermistor. Read more

Got a new part and replaced it. Read more

• Door latch failure
• Won't start
• Will not agitate
• won't spin

Replaced it with the part I ordered from you guys. I had originally had LG come and check it out but they quoted me a price 250 plus tax. I said no way this little piece can cost 1/4 of the whole washing machine. So after finding your price, I you-tubed on how to replace it and I did in 20 min. Thanks youtube and thanks to you guys for such a great price on this switch assembly Read more

• Leaking

First I replaced the filter thinking it was the problem, but that was not the case. Next was replace water supply valve at the back of the refrigerator. It was very easy. The only thing that was in question was how to get the refrigerator side line off of the existing valve. There is a plastic slide clip that you remove and pull the line out and press the line back into the port it came out of. It was a very simple project and took about 20 minutes. Read more

Looking online for ice maker repairs on LG, came across several videos. AppliancePartsPros.com had a very good video, after watching I looked up my model reference and found the assembly I needed. Easy online order had the part in 2 days. I installed it as the video had directed, easy to install with only a screwdriver. Great experience. Read more