Touch Pad

My unit would sometimes start. Sometimes not. Reset and start are the same key and either it did nothing or it would drain or it would start. While the video did match my unit. It was close enough to help. I removed the front per the video and snapped in the new control strip. Fixed in less than 10 minutes with only a manual screwdriver. Read more

I bought the part from APP.com and the replacement was simply. I pulled it into the receptacle, put the door back together and then adhered the new keypad to the door. This tool about 30 mins in total and only need a putty knife to remove the old one and a screwdriver to put the door back together. Probably saved myself a $200-$300 labor repair cost. Read more

I took of the backsplash and took the hose off of the pressure switch and accidently broke off the stem of the pressure switch and the catch parts of the pressure switch. I put some Krud Cutter into the pressure switch hose and blew into it until I got air to flow. I stopped the tub from over flowing and replace the pressure switch and backsplash. Read more

Replaced the control panel (Timer). Getting it out is a bit of a puzzle but doable. Read more

Replaced the control panel Read more

Removed and unplugged dishwasher. Opened door and peeled off touch pad. Removed the screws that held the door together. Gently separated the inner and outer parts of the door. Removed the cable for touch pad. Fed new touch pad cable into door from top. And pressed cable back into fitting. Reassembled door. Plugged dishwasher back in and reinstalled into cabinet. Only one problem with my repair. I should have plugged in the “New” touch pad to see if it it worked properly. It has a led out on it... Read more

Given that I had 14 house guests for a week, I tried calling a Maytag repair man to expedite the fix - unfortunately, he didn't have the part, but did identify the problem as a bad control panel. I ordered the part (#W10235721) from Appliance Part Pros (which was quick and easy) and received the right part the first time and very quickly. To replace the control panel, the Maytag guy said about $200 plus the part. If you have a torx screw driver set, you can do this repair in 15 minutes. ... Read more

I replaced the control panel. I guess the problem could also have been the control board. I felt more certain about purchasing the control panel after removing the old one, and ohm-ing out pins that should have indicated small resistance when pressing front panel buttons, but all indicated open circuit. A result of moisture that ruined the thin wires in the ribbon cable, apparently a common problem of the Maytag/Whirlpool dishwashers and the subject of a class action lawsuit (Maytag would... Read more

Ordered a new control panel and installed it and works great now. Very easy fix. Read more

I removed the control block and carefully removed the damaged faceplate using a sharp knife and a hair dryer. Read more