General Electric Cable Or Retainer

This small replacement clip secures cabinet insulation in place to help maintain proper thermal performance and reduce vibration. A simple, original-equipment style retainer for restoring insulation fit and keeping internal components covered. What it does:

• Holds appliance insulation against the cabinet or inner panels
• Helps prevent insulation from sagging, shifting, or falling into vents or components
• Can reduce noise caused by loose insulation and help maintain temperature control
• Commonly needed when clips are broken, corroded, or missing

• One insulation retainer clip

• Disconnect power (and water if applicable) before accessing internal panels
• Remove access panels or liners to reach the insulation area; retain fasteners
• Push or snap the retainer into the designated hole/slot; some models may require light prying or a screwdriver for removal
• Wear gloves and eye protection to avoid cuts from sharp sheet metal and insulation fibers

This retainer bag secures and positions the bag/assembly inside the appliance so the component stays in place during normal use, helping prevent sagging or misalignment. It's a direct-fit replacement designed to restore proper fit and function. What it does:

• Holds the bag or internal assembly securely in the correct position
• Prevents the bag from shifting, sagging, or catching during operation
• Helps maintain proper airflow and component alignment where applicable
• Resolves symptoms like a loose, sagging, or improperly seated bag/assembly

• One retainer bag

• Disconnect power to the appliance before starting any work
• Remove exterior panels or access covers as required to reach the retainer
• Inspect surrounding clips and mounting points; replace damaged fasteners as needed
• Follow the appliance manufacturer's instructions for reassembly and testing

This wire tie secures and organizes wiring inside the appliance to help prevent chafing and loose connections. Its 7-7/8 inch length is suited for bundling harnesses and routing cables away from heat and moving parts. What it does:

• Fastens and groups wires or small hoses to keep them neatly routed
• Helps prevent wire chafing, abrasion, and contact with sharp edges
• Reduces the chance of intermittent connections from loose wiring
• Keeps wiring away from moving components to reduce noise and wear

• Disconnect power before servicing the appliance
• Position wiring as needed, insert tie and tighten; avoid over-tightening
• Trim excess tie length flush and secure cut end away from wires
• Replace any damaged wiring insulation and verify routing before restoring power

This sump retainer secures the washer's sump assembly to the cabinet, keeping the drain area stable and aligned for proper water flow. Replacing a worn retainer helps stop movement and reduces strain on hoses and seals. What it does:

• Holds the washer sump/collection area in place to maintain correct alignment
• Prevents excess movement that can cause leaks or rubbing on hoses
• Helps reduce vibration-related noise from the drain area
• Supports proper sealing to assist normal draining performance

• Disconnect power and shut off water before beginning any repair
• Use basic hand tools; support the sump while replacing the retainer
• Replace cracked or damaged adjacent components (hoses, seals) as needed