General Electric Cable Or Retainer

This bottom insulation retainer secures oven/refrigerator insulation in place so the appliance maintains proper thermal protection and reduces heat transfer to surrounding components. It helps keep insulation positioned for reliable operation. What it does:

• Holds lower insulation panels or pads securely against the cabinet or liner
• Prevents insulation sagging or displacement that can cause noise or reduced thermal efficiency
• Helps maintain proper clearances to protect wiring and components from heat exposure
• Commonly replaced when the retainer is cracked, broken, or missing

• Service with the appliance powered off and disconnected from its power source
• Inspect surrounding insulation for damage; replace as needed to restore full protection
• Typically installs with clips or screws—retain existing fasteners unless replacement hardware is specified

This inner door sub-assembly is the factory replacement inner panel for the appliance door. It restores the door's inner structure and supports the inner glass and trim for safe, stable operation. What it does

• Replaces a damaged or warped inner door panel that can allow heat/steam to collect between door layers
• Secures and supports inner glass and related trim for proper door alignment
• Reduces rattling or vibration caused by a loose or broken inner door component
• Helps restore a proper seal and consistent cooking/heating performance when the inner panel is compromised

• One inner door sub-assembly

• Disconnect power (and gas, if applicable) before beginning any repair; ensure appliance is cool
• Handle glass and sharp edges carefully; wear gloves and eye protection
• Follow the OEM service manual for disassembly/reassembly steps and recommended fasteners

This small replacement wire retainer secures heater and sensor wiring to the evaporator area, preventing wire contact with sharp edges and maintaining proper routing for reliable defrost operation and safe airflow. What it does:

• Holds heater and thermostat/sensor wires in place near the evaporator assembly
• Prevents chafing, pinching, or accidental contact with moving or hot components
• Helps maintain correct wire routing for consistent defrost performance and temperature sensing
• Reduces risk of intermittent connections or short circuits caused by loose wiring

• Designed for a simple clip-in or screw-mount installation; inspect mounting point for clips or fasteners before replacing
• Disconnect power to the appliance before accessing the evaporator compartment
• Handle wiring gently and ensure secure seating of wires in the retainer before reassembling panels
• If any wiring or insulation is damaged, replace or repair the wiring harness per manufacturer guidance