General Electric Cap Or Cover

Replacement cover for the refrigerator ice bin dispenser bucket. Installs on top of the ice storage bin to seal and protect ice. Needed when cracked or broken.

Plastic housing trim that protects the evaporator coil in your freezer compartment. Replace if your cover is cracked, broken, worn, or missing.

White hinge that secures and supports the refrigerator access cover. Replace if your hinge is cracked, broken, or causing the cover to sag or rattle.

Direct-fit lock cover housing for freezers. Protects the lock mechanism and restores a finished appearance. Replaces cracked, broken, or missing covers.

Replacement ice bin front panel for side-by-side refrigerators. Restores the ice bucket door to keep ice contained. Needed when original is cracked or broken.

Protective cover for your dryer's terminal block electrical connections. Replace if cracked, broken, or missing to safely cover wire terminals.

Rear cabinet cover panel for washers. Encloses the back of the washer cabinet. Replace if cracked, damaged, or missing to restore appearance.

The washer cap handle screw secures the handle cap to the washer door or lid handle assembly. Replace when the handle feels loose, the cap falls off, or the screw is stripped or missing.

Black chevron-style top trim cap for refrigerator upper control area. Replace cracked, chipped, or faded trim to restore front appearance and finish.

This white cover hinge replaces a worn or broken hinge that supports and pivots the appliance cover, restoring proper alignment and smooth opening/closing for the lid. Designed as a direct-fit replacement where specified. What it does:

• Provides a secure pivot point so the cover or lid opens and closes smoothly
• Keeps the cover aligned to prevent sagging, rubbing, or binding
• Restores a proper seal/closure when hinge wear causes gaps or misalignment
• Helps eliminate rattling or excess play caused by a damaged hinge

• Disconnect power (and water if applicable) before starting any repair.
• Handle the lid/cover carefully during removal to avoid dropping or injury.
• Basic hand tools are typically required; follow your model's service diagram for location and fastener details.
• Replace with the same OEM part number to ensure fit.

White plastic corner cap that snaps onto refrigerator door corners to conceal fasteners and protect hinge areas. Replace if cracked, broken, or missing.

Right-hand cap cover for refrigerator compartments. Replaces cracked, broken, or missing covers. Snaps into place on right side panels or shelves.

Protective cover cap for refrigerator temperature sensor. Snaps into place to shield sensor from damage. Replace if cracked, broken, or missing.

White plastic cover cap that conceals mullion screws in your refrigerator. Replaces cracked, broken, or missing screw covers for a finished appearance.

White plastic end cap for refrigerator front grille assembly. Replaces missing, cracked, or broken grille caps. Snaps onto grille edge for clean finish.

Black plastic grille end cap for refrigerator base grilles. Replaces broken, cracked, or missing caps that secure grille panels at the edges.