General Electric Cap Or Cover

This fill tube cover is the molded shield that fits over the refrigerator's water/ice fill tube to protect and insulate the fill path and help direct water into the ice maker. It replaces a cracked, missing, or damaged cover to restore proper fill alignment. What it does:

• Protects and insulates the water/ice fill tube to reduce drafts and condensation
• Helps direct water into the ice maker mold for consistent fills
• Prevents the fill tube from being bumped or misaligned during normal use
• Can reduce water spray or minor leakage caused by a damaged cover

• One fill tube cover

• Disconnect power to the appliance and shut off the water supply before servicing
• Usually snaps into place near the ice maker; handle gently to avoid breaking mounting tabs
• If other fill components are cracked or leaking, inspect and replace them as needed

This water line cover protects and conceals the refrigerator's water supply tubing behind the lower kickplate for a finished look and reduced risk of accidental snagging. Durable plastic shields tubing from contact and helps keep the area tidy. What it does:

• Covers and protects the refrigerator water supply line from accidental pulls or abrasion
• Keeps the tubing out of sight for a neater appearance
• Helps reduce noise from loose tubing contact with other components
• Supports proper routing of the water line to the ice maker/water dispenser

• One water line cover

• Disconnect power and shut off the water supply before servicing
• Remove the kickplate or access panel per the owner's manual to reach mounting points
• Align cover with the routing area and secure with existing clips or fasteners; do not force or modify

This water tank cover protects and seals the refrigerator's internal water reservoir, helping keep the tank clean and preventing debris from entering the water system. It restores the tank's enclosure after maintenance or replacement. What it does

• Covers and protects the refrigerator water tank to help maintain sanitary water storage
• Helps keep debris and dust out of the tank and water supply area
• Supports proper alignment and fit of the tank assembly when reinstalled
• Can reduce chances of water contacting nearby components during routine use

• This listing is for the water tank cover only

• Replace with the refrigerator powered off and water supply shut off when applicable
• Inspect mating tank and nearby seals for damage; replace any damaged components before reassembly
• Secure the cover in its correct orientation and verify it seats flush to prevent leaks

A small sealing cap used to close and protect a service port or tubing end, helping prevent leaks and contamination. Replaces a worn or missing cap to restore a tight seal and tidy appearance. What it does:

• Seals off a service port or tubing end to prevent water or air leaks
• Protects the fitting from dirt, debris and corrosion when not in use
• Helps maintain proper system pressure by providing a secure closure
• Can stop minor drips caused by a damaged or missing cap

• Intended for a direct replacement; fit before installing
• Turn off supply (water/electric) and relieve pressure before removing old cap
• Hand-tighten only unless otherwise specified by manufacturer to avoid damage
• Inspect mating surface for debris or damage and clean before installing new cap

The Inner Door Cap is an OEM part for GE electric dryers. Located inside the dryer door opening, it functions as the interior lining that shields insulation material. 

GE dryers incorporate insulation around the door area to limit heat loss during cycles. The plastic cap acts as an additional barrier behind the metal door. This maximizes efficiency by retaining warm air circulation only inside the drum. 

Causes of a damaged cap include prolonged heat exposure leaving it brittle with use over time or physical stresses cracking the plastic.

Symptoms of a failed cap include:

• Drafts noticeable near the door seal   
• Reduced internal air temperatures requiring extended cycle times
• Dust or debris visible behind the door

Note: Right side

Compatible with some Kenmore dryers.