General Electric Cap Or Cover

A small sealing cap used to close and protect a service port or tubing end, helping prevent leaks and contamination. Replaces a worn or missing cap to restore a tight seal and tidy appearance. What it does:

• Seals off a service port or tubing end to prevent water or air leaks
• Protects the fitting from dirt, debris and corrosion when not in use
• Helps maintain proper system pressure by providing a secure closure
• Can stop minor drips caused by a damaged or missing cap

• Intended for a direct replacement; fit before installing
• Turn off supply (water/electric) and relieve pressure before removing old cap
• Hand-tighten only unless otherwise specified by manufacturer to avoid damage
• Inspect mating surface for debris or damage and clean before installing new cap

Replacement lamp cover for your dryer's interior light. This plastic cover protects the bulb and lens. Order now if yours is cracked, broken, or missing.

Replace your dryer's condenser cover if cracked, broken, or missing. This protective cap shields the condenser unit from debris and damage. Direct fit.

Protective cover for the main wiring harness on laundry centers and washer-dryer combos. Replaces cracked, broken, or missing covers that expose wiring.

Replace your dryer's door hinge cover if it's cracked, broken, or missing. This plastic cap installs over the hinge assembly for a clean appearance.

Left-side inner door cap for dryers. Replaces cracked, broken, or missing door trim caps. Installs on the interior edge of the dryer door panel.

Interior lining cap that shields insulation inside the dryer door opening. Replace if cracked, broken, or missing to restore proper door coverage.

Plastic cover that conceals the door hinge mechanism on your dryer. Replace if cracked, broken, or missing to restore a clean finished appearance.

Covers the pump access opening on your washer. Replace this cap if it's cracked, broken, missing, or no longer securely closes the access panel.

Access door for washer pump compartment. Installs on front or bottom panel to cover pump area. Replace if cracked, broken, or missing for proper coverage.

Replacement pump access door for your washer. Covers the pump compartment panel opening. Order a new door if yours is cracked, broken, or missing.

Replacement cap cover for your washer. Installs on the top or side panel to protect internal components. Replace if cracked, broken, or missing.

Replace your washer's siphon break cap if it's cracked, broken, or missing. This protective cover installs on the siphon break assembly to prevent leaks.

Replace your washer's softener and bleach dispenser cover if it's cracked, broken, or missing. Fits on top of the dispenser drawer assembly.