General Electric Dispenser Parts

Replace your dishwasher's ring nut with gasket if the original is cracked, worn, or missing. Secures components and ensures a proper seal.

Insulating switch cover for dishwashers. Protects electrical switch components from moisture and heat. Replace if cracked, broken, or missing.

If rinse aid leaks from your dishwasher dispenser, this cap seals the reservoir to prevent leaks and ensure proper dispensing during wash cycles.

Fix liquid detergent leaking or not dispensing in your dishwasher. Dispenser assembly replacement takes 30-45 minutes with basic tools.

Replacement cap that covers and protects the control panel plug connection on your dishwasher. Needed when the original cap is cracked, broken, or missing.

Dishwasher service dome coarse filter traps food debris during wash cycles. Replace if leaking, cracked, or worn to prevent water leaks. Verify fit by model.

Fix residue buildup in fabric softener compartment with this washer dispenser drawer. Replaces worn or cracked drawers that fail to dispense properly.

Fix fabric softener or bleach not dispensing in your washer. This dispenser drawer assembly replaces cracked or clogged units. Moderate DIY repair.

Fix a dishwasher that won't dispense detergent with this dispenser lever microswitch. Detects dispenser door position for proper release timing.

Fix a dishwasher detergent dispenser that won't release soap with this detergent cup shaft. Common repair for dispenser door issues. Easy DIY fix.

This pump housing channels washer drain water from the tub to the drain pump and helps seal the pump assembly to prevent leaks. Replacing a cracked or worn housing restores proper drainage and helps stop leaks under the washer. What it does

• Directs wastewater from the tub into the drain pump so the machine can pump out water
• Seals the pump to the washer tub to help prevent leaks at the base
• Can cause poor draining or standing water when cracked or damaged
• A damaged housing may produce unusual pump noises or visible leakage

• 1 pump housing

• Disconnect power and shut off water before starting any repair
• Drain remaining water from the washer and remove the access panels as required
• Installation typically requires removing the drain pump/motor and transferring seals or gaskets
• Inspect clamps and hoses for wear and replace if needed; test for leaks after reassembly

Protective cover for dishwasher power board. Shields electrical components from debris and accidental contact. Replace if cracked, broken, or missing.

Plug button cap for dishwasher control panel. Replaces worn, cracked, or missing button covers. Restores clean appearance to front controls.

Fix your dishwasher detergent not dispensing with this timer lever. Controls soap release timing during wash cycles. Standard DIY repair.