Guard, Shield, Barrier Parts

This flat case is the replacement outer housing that secures and protects internal components, restoring the appliance's exterior fit and function. It's a direct-fit cosmetic and protective part for affected assemblies. What it does

• Replaces cracked, warped, or damaged housing that exposes internal parts
• Restores proper alignment and closure of the surrounding panel or assembly
• Helps prevent dust, moisture, and debris from reaching internal components
• Stops rattles or vibration caused by a loose or broken case

• One flat case housing

• Disconnect power and water before starting work
• Inspect mounting clips and screws; replace any damaged fasteners for a secure fit
• Handle plastic parts carefully to avoid cracking during installation
• If access requires disassembly of other panels, keep track of all fasteners and their locations

This is a replacement outer case housing that covers and protects internal appliance components, keeping parts aligned and reducing exposure to dust and damage for reliable operation. What it does:

• Protects internal components and wiring from dust, moisture, and physical contact
• Holds and aligns panels, control components, or assemblies in the correct position
• Helps reduce vibration and rattling by securing moving parts
• Restores proper fit and finish to the appliance exterior when a cracked or damaged case causes gaps or misalignment

• One replacement case housing

• Disconnect the appliance from power before starting any repair
• Remove any trim panels or covers as needed; retain all fasteners for reassembly
• Handle plastic parts carefully to avoid cracking; test fit before tightening all fasteners
• Ensure connectors are seated correctly and wires are routed per original path

Range door latch shield that covers and protects the top latch mechanism. Replace if cracked, broken, or missing to restore proper door alignment.

Rear wall shield for ranges. Protects the back wall cavity from heat and debris. Replace if cracked, bent, or damaged to maintain proper insulation.

A replacement wire shield for the stove/oven vent that protects wiring from heat and abrasion, helping maintain reliable oven vent performance and reduce wire damage risk. What it does:

• Shields vent-area wiring from heat and physical wear
• Helps prevent wiring chafe and shorting caused by rubbing or contact
• Supports safe routing of harnesses near the stove/oven vent
• Addresses symptoms such as exposed or frayed wires near the vent, burning smell, or intermittent electrical faults

• One wire shield as shown

• Disconnect power to the appliance before attempting any service
• Handle carefully to avoid bending or nicking the shield or adjacent wiring
• Reinstall using existing mounting points and fasteners; replace any damaged clips or hardware