Valve

If your range burner won't ignite, stay lit, or adjust flame properly, the top burner valve may need replacement. Restores precise heat control.

Fix a burner that won't light or has an uneven flame with this gas cooktop valve. Controls gas flow to a single burner for reliable ignition and heat.

Burner won't light or flame is uneven? This top burner valve controls gas flow to restore reliable ignition and consistent flame on your gas range.

This water inlet valve assembly controls water flow into the washer tub, restoring correct fill and water selection so cycles start and run properly. It replaces a failed or leaking inlet valve to help the machine fill and pause as designed. What it does

• Opens and closes to allow cold and/or hot water into the washer during fill cycles
• Stops water flow when the machine reaches the set fill level
• Commonly replaces valves that leak, fail to fill, or cause the washer to overfill
• Works with the washer's control signals to route water only when needed

• Disconnect power and shut off household water supply before replacing the valve
• Tighten fittings to correct torque to avoid leaks; use new seals if provided or recommended

Fix a washer that won't fill or fills slowly with this water inlet valve. Controls hot and cold water flow into the tub. Direct replacement part.

This is a water inlet valve that controls the flow of water into the refrigerator's water supply system, typically feeding the ice maker and/or water dispenser. It is an electrically operated solenoid valve that opens and closes in response to signals from the control board. Replace this valve if the ice maker is not filling with water, the water dispenser has low or no flow, or if the valve is leaking or buzzing without dispensing water.

Ice maker not filling or water dispenser not working? This refrigerator water inlet valve controls water flow to both features. DIY-friendly repair.

The Water Inlet Valve is an OEM replacement part for Whirlpool French-door refrigerators. It regulates incoming water supply for critical appliance features such as the ice maker and water dispenser.

Symptoms of a failing inlet valve may include:

• Low water pressure at the dispenser tap  
• Irregular or inadequate ice production
• Fault codes relating to fill or flow errors
• Leaks or drips from valve connections

Causes relate to regular wear expected over many seasons of use. Mineral accumulation inside narrow valve ports is also common given years of exposing components to residential water treatment. 

This authentic Whirlpool replacement is compatible with some Maytag, Jenn-Air and Amana side-by-side refrigerator models as well.

Fix a washer that won't fill with water or has slow fill issues with this water inlet valve. Controls water flow into your machine. DIY-friendly repair.

Fix burners that won't light, won't adjust, or have uneven flames with this gas cooktop burner valve. Controls gas flow to individual burners.

If your cooktop burner won't ignite or hold a flame, this gas valve controls fuel flow to restore normal operation. Direct replacement part.

This is a gas shut-off valve used in gas ranges and ovens to control the flow of gas to the burners or oven. It opens and closes to allow or stop gas flow as needed during normal operation. Replace this valve if you detect a gas smell near the range, if a burner won't light or won't shut off completely, or if the valve is visibly damaged or leaking.

Burner won't light or flame is uneven? This cooktop top burner valve controls gas flow to individual burners. Common fix for flame control issues.