Valve

Fix a washer that won't fill with water or has slow fill issues with this water inlet valve. Controls water flow into your machine. DIY-friendly repair.

Fix burners that won't light, won't adjust, or have uneven flames with this gas cooktop burner valve. Controls gas flow to individual burners.

If your cooktop burner won't ignite or hold a flame, this gas valve controls fuel flow to restore normal operation. Direct replacement part.

Burner won't light or flame is uneven? This cooktop top burner valve controls gas flow to individual burners. Common fix for flame control issues.

Burner won't light or heat properly? This top burner valve controls gas flow to restore proper flame adjustment. Direct-fit part for gas ranges.

Fix a burner that won't light, won't adjust heat properly, or stays on constantly with this range top burner valve. Moderate DIY repair in 30-45 minutes.

Fix a gas range burner that won't light or stay lit with this safety valve replacement. Controls gas flow to ensure safe burner operation on your range.

This inlet valve controls the flow of water into the appliance, restoring proper fill and water delivery when the original valve leaks, fails to open, or allows continuous filling. A direct-fit replacement when the valve assembly is damaged. What it does:

• Opens and closes to allow water into the appliance during cycle fill
• Stops water flow when the fill is complete to prevent overfilling
• Commonly replaced for symptoms like no water fill, slow fills, or constant leaking/overflow
• Works with factory water lines and electrical connectors to regulate supply

• One inlet valve assembly

• Disconnect power and shut off the water supply before starting
• Handle valve and solenoids carefully; avoid damaging electrical terminals or inlet fittings
• Verify proper hose and electrical connections and test for leaks after installation

Fix weak flames or burners that won't ignite with a new safety valve. Controls gas flow to burners for reliable ignition and safe shutoff on ranges.

This replacement valve kit controls water flow into the appliance, restoring proper fill and operation. It replaces a worn or failing inlet valve assembly to help stop leaks and restore normal fill cycles. What it does:

• Opens and closes to allow water into the appliance during fill cycles
• Stops water flow when cycle is complete to prevent overfilling
• Commonly used to address no-fill, slow-fill, or continuous-fill symptoms
• Helps stop valve-related leaks when the valve assembly is the source

• One valve kit

• Disconnect power to the appliance and shut off the water supply before starting
• Handle and position the valve carefully; use appropriate hand tools
• Inspect hoses and fittings and replace any damaged seals or clamps

Air conditioner not heating or cooling properly? The reversing valve body controls refrigerant flow direction in heat pump systems. Essential for mode switching.

Washer won't fill or won't stop filling? This water inlet valve controls water flow into the tub. DIY-friendly repair, typically takes 10-15 minutes.