Valve

Fix a burner that won't light or ignite, won't adjust flame, or has a frozen stem. This gas burner valve controls flow for proper ignition and heat.

If your cooktop burner won't ignite or flame is uneven, this gas valve kit controls fuel flow to restore proper operation. Moderate DIY repair.

Fix a washer that won't fill with water or stops mid-cycle with a new water inlet valve. Controls water flow into the tub during wash cycles.

Fix your refrigerator not filling with water or overfilling with this water inlet valve. Controls water flow during fill cycles. Easy DIY repair.

This gas valve controls the flow of gas to a surface burner on a gas range. It is connected to the burner control knob and regulates flame height from low to high settings. Replace this valve if the burner won't ignite, the flame cannot be adjusted properly, or you detect a gas smell when the knob is in the off position.

Washer filling too slowly or with wrong water temperature? This mixing valve controls hot and cold water flow. Moderate DIY repair in under an hour.

This is a gas valve for a range cooktop that regulates the flow of gas to a surface burner. It connects to the control knob and allows you to adjust the flame size from simmer to high heat. Replace this valve if the burner won't ignite, the flame is inconsistent, the knob feels loose or unresponsive, or you smell gas when the burner is turned off.

Fix a washer that won't fill with water or fills slowly. This triple water inlet valve controls water flow to your machine. Moderate DIY repair.

This water valve assembly controls water flow into the appliance, providing reliable fill operation for the dispenser/ice system. It replaces a worn or failed valve to restore proper water delivery and help prevent unwanted leaks. What it does:

• Opens and closes water flow to the appliance when signaled by the control
• Stops water flow to prevent overfilling or flooding when functioning correctly
• Commonly used when the appliance won't fill, makes no water available, or continuously runs water
• Helps ensure proper water supply to ice makers and dispensers

• Disconnect power and shut off the water supply before starting work
• Allow access to the valve and relieve any line pressure before disconnecting fittings
• Inspect and replace any damaged hose or seal while installing the new valve
• Test for proper operation and leaks after installation

This is a gas valve that controls the flow of gas to a surface burner on a gas range or cooktop. It connects to the burner control knob and regulates the flame from high to low settings. Replace this valve if a burner will not ignite, the flame cannot be adjusted properly, you smell gas when the knob is in the off position, or the knob turns without resistance.

Water backing up into your dishwasher after a cycle? The drain check valve prevents wastewater from flowing back. Moderate DIY repair with pump access.

Fix gas smell when range is off with this safety valve lockout clip. Secures gas valve actuator to prevent unintended movement. Simple DIY repair.

Burner won't ignite or control knob is hard to turn? This top burner valve controls gas flow to surface burners. Moderate DIY repair with basic tools.

This dispenser valve assembly controls water flow to the fridge door dispenser for reliable dispensing and shutoff. It replaces a failed valve to restore proper water delivery and stop unwanted dripping or leaks. What it does

• Opens and closes the water passage when the dispenser actuator is pressed to deliver water to the glass.
• Seals the water line to prevent drips or continuous flow when the dispenser is idle.
• Helps stop intermittent dispensing or no-water issues caused by a faulty valve.
• Works with the door dispenser plumbing—electrical/connectors remain unchanged.

• Disconnect power and shut off the refrigerator water supply before starting.
• Remove the refrigerator door panel or access cover per your model's service instructions to reach the valve.
• Verify electrical connector seating and water line fittings are secure; replace any damaged tubing or seals.
• Test for leaks and proper dispensing after restoring power and water.

If your range burner won't ignite, stay lit, or adjust flame properly, the top burner valve may need replacement. Restores precise heat control.