General Electric Housing Or Cover

Back panel for electric ranges. This housing cover attaches to the rear of the unit. Replace if cracked, damaged, or missing to restore appearance.

Replacement wire terminal box for range hoods. Provides protected junction point for wiring connections. Install when original box is cracked, broken, or missing.

36-inch range hood cover housing that installs on the exterior of your ventilation unit. Replaces cracked, dented, or discolored covers.

Protective housing cover that encloses and secures the oven's cooling fan assembly. Replace if cracked, broken, or missing to restore proper enclosure.

Replace your damaged or missing range burner box cover. This protective housing installs over the burner assembly. Ideal for cracked or broken covers.

Bottom burner box housing for gas ranges. Protects burner components and maintains proper airflow. Replace if cracked, rusted, or damaged to restore appearance.

Replace a cracked or broken dryer blower housing. This cover protects the blower wheel assembly and mounts inside the dryer cabinet near the drum.

Gas heater housing for dryers. Encloses and protects the gas heating assembly. Replace if cracked, damaged, or missing to restore proper enclosure.

This is an H-shaped edge connector used in the dryer's power control housing area. It provides an electrical connection point between wiring harnesses or circuit boards within the control section of the dryer. Replace this connector if you notice intermittent dryer operation, loose wiring connections, or visible damage such as burnt or corroded terminals.

Molded access cover that houses and protects the washer pump and plumbing. Replace if cracked, broken, or missing to restore factory protection.

Protective housing that encloses the washer pump area. Replace if cracked, broken, or missing to restore proper coverage around the drain pump assembly.

Bottom housing for washer diverter box assembly. Replaces cracked, broken, or damaged diverter box bottom cover. Installs on water distribution system.

Replacement diverter box top cover for washers. Directs water flow to upper spray components. Replace if cracked, broken, or leaking. Restores proper operation.

White plastic housing that secures the dispenser meter assembly in your washer. Replace if cracked, broken, or missing to restore proper alignment.

Electric controller box housing for room air conditioners. Replaces cracked, broken, or missing electrical component enclosures. Protects wiring.