General Electric Housing Or Cover

This condenser fan housing provides the mounting and airflow channel for the refrigerator condenser fan, helping maintain proper condenser cooling and airflow for efficient operation. Replaces a damaged or cracked housing to restore secure fan mounting and airflow direction. What it does:

• Secures the condenser fan motor and blade in the correct position behind the condenser coils
• Directs airflow across the condenser to help dissipate heat from the refrigeration system
• Reduces vibration and fan movement that can cause noise or wear
• Can prevent fan contact with other components if the original housing is cracked or broken

• One condenser fan housing

• Disconnect power to the appliance before starting any repair
• Some disassembly (rear access panel or toe grille) is typically required to reach the condenser area
• Handle sheet metal carefully; wear gloves to avoid cuts
• Reuse existing mounting hardware when possible; verify fan/motor alignment before fully tightening

This dispenser housing shield replaces the trim piece that surrounds and protects the refrigerator's ice/water dispenser opening, restoring appearance and keeping dispenser components covered. Fits the factory mounting points for a direct fit. What it does:

• Covers and protects dispenser controls and internal components from spills, debris, and accidental impact.
• Guides dispensed water/ice into the cup area to reduce splashing.
• Prevents drafts and minimizes cold air loss around the dispenser opening.
• Worn, cracked, or loose shields can cause visible damage, wobbling, or allow debris into the dispenser area.

• One dispenser housing shield

• Disconnect power and shut off water to the refrigerator before beginning service.
• Typically installs behind the dispenser bezel or front panel; some models require removing the dispenser trim or control panel first.
• Retain all screws and clips from the original part; use only the specified fasteners for reassembly.