General Electric Insulation, Sound Dampening Parts

This condenser panel replaces the outer cover that protects the refrigerator condenser and helps direct airflow for efficient cooling. It restores proper airflow path and keeps condenser components shielded from debris. What it does:

• Covers and protects the condenser coil and nearby components from dust and physical damage
• Helps channel airflow over the condenser to support efficient heat rejection
• Can reduce vibration noise caused by loose or damaged panels
• Symptoms a failing panel can cause: visible damage, rattling or increased noise near the condenser area, or decreased cooling performance if airflow is obstructed

• One condenser panel (outer cover)

• Disconnect power to the appliance before beginning any work
• Remove access panels and mounting screws to replace the old condenser panel; retain hardware
• Handle edges carefully; panels may have sharp metal edges

This self-adhesive foam strip provides a thin, flexible seal used to fill gaps, reduce vibration, and block drafts or moisture around appliance components. It restores a close fit and helps reduce energy loss and noise. What it does:

• Seals small gaps between panels or trim to reduce drafts and moisture intrusion
• Dampens vibration and rattling from loose or misaligned parts
• Helps prevent dust and debris from entering sensitive areas
• Supports proper airflow by reducing unwanted leaks that can affect cooling

• Clean and dry mating surfaces before applying to ensure adhesive bonds properly
• Trim to fit with scissors or a utility knife; press firmly along the entire length to secure
• For best results, apply at room temperature and allow adhesive to set before reassembling

This lower foam pad cover cushions and seals the appliance's lower access area to reduce vibration and protect internal components. It helps maintain quiet operation and prevents dust or debris from entering sensitive gaps. What it does

• Provides a soft barrier that dampens vibration and reduces noise from moving parts.
• Helps keep dust and debris out of lower openings and cavities.
• Protects edges and components from direct contact and wear.
• Supports proper fit and alignment of the lower access panel.

• Designed for simple replacement; remove the lower access panel to reach the pad area.
• Confirm orientation and full seating of the pad before reattaching the panel to avoid gaps.
• Use basic hand tools as needed and disconnect power before servicing nearby electrical components.
• If adhesive is used, replace with manufacturer-recommended adhesive or fasteners to ensure a secure fit.