General Electric Shaft Or Pin

This replacement key pivot is the small pivoting pin that supports the refrigerator/freezer door key or latch mechanism, restoring secure pivoting and smooth operation at the key location. A direct-fit OE-design replacement. What it does

• Provides the pivot point for the door/key mechanism so the key or latch rotates smoothly
• Restores proper alignment when the original pivot is worn, bent, or broken
• Helps prevent a loose or wobbly key or a latch that fails to engage
• Works as a simple, serviceable part of the door/lock assembly

• One key pivot

• Disconnect power to the appliance before beginning any repair
• Remove door trim or access panel as needed; keep small parts organized
• Replace the pivot and check movement; avoid forcing parts that do not align

Switch actuator pin for refrigerators. Installs in door or control assembly to trigger switches. Replace if broken, bent, or missing to restore proper fit.

Switch actuator pin for refrigerator door or dispenser assembly. Replaces broken, worn, or missing pins that activate switches. Direct fit component.

A small spring-style cotter clip that secures shafts and pins to keep moving parts in place. Restores a secure fit to linkage, rods, and pivot points so components stay aligned and don't slip free during operation. What it does:

• Holds shafts, pins and rods in position to prevent components from sliding off
• Provides a spring tension lock around a grooved pin or hole for reliable retention
• Commonly used on linkage, pivots and fastener pins where a compact retaining clip is needed
• Helps stop rattling, loose connections or parts that drop out of place

• Disconnect power before servicing any electrical appliance and work with the appliance in a stable position
• Use needle-nose pliers to spread and install the clip over the pin groove; ensure it seats fully
• Inspect mating pin/hole for wear or damage and replace if deformed
• Replace with an identical clip size and style to maintain secure retention

Support rod that reinforces the refrigerator door handle assembly. Replace this rod if your handle feels loose, wobbles, or the support bar is cracked or broken.

This replacement plunger restores proper valve action in your appliance's water/ice system so the dispenser and ice maker control water flow reliably. It provides a simple, low-cost fix for valve sticking or worn internal parts. What it does

• Moves inside a water/valve assembly to open and close water flow for the dispenser or ice maker
• Helps stop continuous or unwanted water flow when functioning correctly
• Can correct symptoms like slow or no water dispensing, intermittent flow, or ice maker fill issues
• Works as an internal service part when the valve is disassembled for repair

• One plunger

• Disconnect power and shut off the water supply before starting work
• This small internal part requires valve disassembly; follow the valve manufacturer or service manual for safe removal and reassembly
• Inspect valve seals and springs during service; replace any damaged components to ensure a reliable repair