Need Help?
Call
5/16-18 hex screw secures panels and components in laundry centers. Replace stripped, broken, or missing fasteners to restore proper fit and alignment.
Hex pan thread screw for washer dryer combo units. Secures panels and components to the frame. Replace missing, stripped, or damaged fasteners.
Truss head tapping screw for washer assembly. Replaces stripped, corroded, or missing screws in various mounting locations. Essential hardware piece.
Replacement mounting screw for washer pedestals. Secures pedestal to washer base. Order if original screw is stripped, missing, or damaged.
Replacement mounting screw for washer assemblies. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.
M5 mounting screw for washer assembly. Secures panels, brackets, and internal components. Replace if stripped, corroded, missing, or damaged.
M8 hex nut secures washer components and panels. Replace if damaged, stripped, or missing to restore proper clamping force and eliminate loose connections.
Replacement mounting bolt for washer assembly. Secures internal components and housing panels. Needed when original bolt is stripped, missing, or damaged.
Mounting screw for washers, dryers, and pedestals. Replaces broken, stripped, or missing screws that secure panels and components. Essential hardware.
I had to remove the front panel of the washing machine and top of the washing machine. i started by removing all the top screws as shown in one of videos. disconnected all the electrical wires (i have a commercial washer) and lifted the front panel over the back of the machine. i was then able to remove the top of the washing machine to give me access to the tub straps and the corresponding screws. i removed the broken straps and then was able to remove the tub cover by pushing down it down... Read more
8-18 AB IHW 5/8 S
Size: 1/4 - 20 b.
OK kids, pay attention! This was my second attempt @ this repair. My first repair started leaking right away and had to be re-done about 6 months later. HERE IS THE PROBLEM!. In the video, you'll notice that (while putting it back together) when you put the square hole washer and split-ring over the shaft, they look to land atop the rubber seal, buy when you do this in real life, there is a gap between the seal and the washer. (This gap was close to a 1/4 inch). I THINK that the first time I... Read more
Size: 8-18 b.
Purchased new RPS Hall Effect sensor, pulled rotor and stator and installed new RPS module. Works fine after new sensor! Repair took about 30 minutes. Perfect! Read more
Package of 12 screws with washers for securing washer panels, trim, and components. Replace missing, stripped, or damaged fasteners to restore fit.
Replacement mounting nut for air conditioner units. Secures panels and components during installation. Needed when original nut is stripped, lost, or damaged.
6 - 10 pl flp 1/2 s
Replaced water line & both damaged dispenser parts. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.