General Electric Screws, Nuts, Washers

This silicon controlled rectifier (SCR) is a replacement power-control semiconductor that helps regulate current to heating and motor circuits, restoring proper cycling and output in affected appliances. What it does:

• Controls and switches power to heating elements or motors by gating current flow
• Helps the appliance regulate temperature or motor speed when functioning correctly
• A failing SCR can cause no heat, intermittent heating, or erratic motor behavior
• Designed to mount to a flange with a .625-inch tab for electrical connection

• Always disconnect power at the breaker or unplug the appliance before servicing
• Handle the SCR by its edges; avoid touching terminals and observe ESD precautions when possible
• Verify proper orientation and secure mounting to the heatsink or chassis per the service manual

This ST4 x 10 self-tapping screw secures lightweight appliance panels and components, providing a reliable fastener for repairs and maintenance. It's a direct-fit hardware piece commonly used on control panels, trim and internal bracketry. What it does:

• Fastens plastic or thin metal panels and small internal parts without a nut
• Holds control housings, trim pieces, and access panels in place
• Helps stop rattles and loose panels when the correct fastener is installed
• Common replacement when original screws are stripped, missing, or corroded

• Use the correct ST4 screwdriver or compatible bit to avoid stripping the head
• Start threading by hand to ensure alignment before driving with a driver
• Tighten until snug; avoid over-torquing which can crack plastic parts
• Disconnect power and follow appliance safety instructions before servicing

8-18 AB IHW 5/8 S

Size: 1/4 - 20 b.

Size: 8-18 b.

This is a package of 12 screws each paired with a washer—small fasteners used to secure panels, trim and components on compatible appliances. Replacing missing or stripped screws restores proper fit and reduces vibration or rattling. What it does

• Secures panels, trim pieces, brackets and small components in place
• Washer helps distribute load and prevents screw heads from pulling through thin materials
• Fixes symptoms like loose panels, rattling parts, or missing hardware
• Use matching screws when reassembling after repair to ensure correct fit

• One package containing twelve screws with washers

• Power off and unplug the appliance before starting any repair
• Hand-start screws to avoid cross-threading; finish snugly but do not overtighten
• Keep removed hardware organized and replace with the correct size and thread type rather than forcing the fastener

6 - 10 pl flp 1/2 s

This is a #10-32 x 3/4 truss-head screw designed to fasten small appliance panels and components securely. It replaces missing or worn fasteners to restore stable mounting and reduce rattles or movement. What it does:

• Secures trim, control panels, brackets, and small assemblies
• Restores tight mounting to stop panel vibration or rattling
• Keeps electrical and mechanical components properly aligned
• Works where a #10-32 machine screw with a short 3/4" length and truss head is required

• Disconnect power before working on the appliance
• Use the correct screwdriver or nut driver to avoid stripping the head
• Tighten until secure; avoid over-tightening which can strip threads or crack plastic
• Keep removed hardware organized for reinstallation

Specs: 8-32 ca hxw 1/2