General Electric Bracket & Flange

This motor bracket secures the appliance motor to the housing, keeping the motor stable and aligned for reliable operation. It's a direct-fit replacement designed to restore proper motor positioning and reduce vibration or noise. What it does:

• Holds and supports the motor assembly in the correct position
• Maintains alignment between the motor and driven components (fans, pulleys, etc.)
• Reduces motor vibration and prevents contact with adjacent parts
• Faulty or cracked brackets can cause rattling noises, excessive vibration, or motor misalignment

• Install with power disconnected; follow manufacturer instructions for access and disassembly
• Use the factory mounting hardware and torque specs where specified
• Inspect surrounding mounts and fasteners; replace any worn or damaged hardware

This foam brace cushions and supports internal components to reduce vibration and prevent rubbing or contact damage. It helps dampen noise and holds parts in position for more reliable operation. What it does:

• Provides cushioning between panels and components to prevent wear from contact
• Dampens vibration and reduces rattling or buzzing noises
• Helps maintain component alignment and spacing during operation
• Protects wiring and hoses from chafing where mounted near moving parts

• One foam brace

• Disconnect power to the appliance before beginning any repair
• Remove the appropriate access panel or cabinet to reach the mounting location
• Position the foam brace flush against the mating surface; trim only if a precise fit is needed
• Do not use solvents or excessive adhesive unless OEM instructions specify; replace if damaged or degraded

This upper front brace is a replacement support bracket that helps secure and align the appliance's front panel for stable operation and proper fit. It restores structural support when the front panel is loose or misaligned. What it does:

• Provides structural support for the upper front panel and surrounding cabinet area
• Helps keep the front panel aligned to improve door/latch engagement and seal
• Reduces panel movement that can cause vibration or rubbing noises
• Restores proper fit after impact or worn mounting points

• One upper front brace

• Disconnect power to the appliance before beginning any work
• Remove the front panel or dryer cabinet access panels to reach the brace as needed
• Support the panel while removing/installing the brace to avoid damage or pinched wiring
• Use appropriate hand tools and follow OEM diagrams for screw locations and torque

This custom panel bracket kit secures a replacement or custom control panel to the appliance, keeping the panel aligned and stable for reliable button access and a finished appearance. What it does:

• Mounts and anchors a custom or replacement control panel to the appliance frame
• Helps prevent panel movement, rattling, or misalignment that can interfere with controls
• Restores proper panel fit after panel removal or replacement
• Provides a mounting point for trim and control assemblies when replacing panels

• Disconnect power to the appliance before beginning any service.
• Follow the appliance service manual to remove the control panel and access mounting points.
• Align brackets and any included hardware before tightening; avoid overtightening screws.

This bracket gasket felt is a thin felt cushioning strip that mounts to a bracket or cabinet to reduce metal-on-metal contact and quiet vibration. It helps protect finishes and prevents rattles where parts meet. What it does

• Cushions contact between a bracket and cabinet or other metal parts to reduce noise and wear
• Helps prevent scratching and scuffing on mating surfaces
• Reduces vibration-driven rattles around the bracket area
• Simple, passive part with no electrical function

• Disconnect power to the appliance before beginning any work when applicable.
• Remove the bracket or access panel to expose the mounting area; replace the old felt with the new strip in the same position.
• Press the felt into place; secure using the original fasteners or adhesive method used by the manufacturer.
• Wear gloves to protect hands from sharp edges.