General Electric Bracket & Flange

This bracket secures the oven/range hot surface indicator light so the indicator stays properly positioned and visible. It restores the light's mounting after breakage or wear, helping you know when a surface or element is hot. What it does:

• Holds the hot surface/indicator light in the correct position behind the console or cooktop lens
• Keeps the indicator light aligned and stable so the hot-surface warning is visible
• Replaces a cracked, bent, or missing bracket that causes a loose or non-seated indicator
• Helps prevent the indicator from rubbing against other components

• One replacement hot light bracket

• Disconnect power to the appliance before starting any repair
• Remove control panel or bezel per your model's service instructions to access the bracket
• Support and align the indicator lamp while fastening the bracket to avoid damaging the bulb or lens

This is a replacement bracket that secures the cooktop/range hot surface indicator lamp so you can see when a surface is hot. It restores proper positioning and support for the indicator light assembly. What it does

• Holds the hot surface indicator lamp in the correct position for visible, reliable indication
• Keeps the lamp aligned and stable to prevent rubbing or disconnection during use
• Helps maintain the cooktop's visual hot-surface warning so users avoid accidental contact
• Compatible with the original indicator lamp assembly design and mounting points

• One hot light bracket (mounting bracket) as shown

• Disconnect power to the appliance before starting any work to avoid shock or injury
• Handle indicator lamp and wiring gently; avoid pulling on wires or touching bulb glass with bare hands
• Retain original screws and clips unless replacement fasteners are specified

This offset bracket secures and repositions appliance components to restore proper alignment and support. It replaces a worn or damaged mounting bracket to stop movement and help eliminate noise or misalignment issues. What it does:

• Provides a stable mounting point for panels or assemblies that need offset positioning
• Restores proper alignment when a bracket is bent, cracked, or missing
• Helps stop rattling, vibration, or sagging caused by a loose support
• Works as a direct-fit replacement for the OEM offset bracket

• Disconnect power to the appliance before starting any repair
• Access may require removing exterior panels or trim; keep fasteners organized
• Use the existing mounting hardware unless replacements are specified

This bracket relay board secures and connects a range/oven relay assembly to the appliance chassis, restoring a stable mounting point for reliable power switching. Designed to hold relays and related wiring in the correct position. What it does:

• Provides a secure mounting platform for the relay assembly to keep electrical contacts aligned.
• Maintains proper spacing and support for relay wiring to reduce strain and intermittent connections.
• Helps prevent relay movement or vibration that can cause arcing or noise during operation.
• Restores factory mounting when replacing a damaged or bent relay bracket.

• Disconnect power to the appliance before beginning any repair to avoid shock or injury.
• Handle connectors and wiring gently; ensure all wire terminals are fully seated on the relay board.
• Use existing mounting hardware or manufacturer-recommended fasteners; tighten screws to a snug fit without over-torquing.