General Electric Bracket & Flange

Upper duct bracket assembly for over-the-range microwaves. Mounts to the top of the unit to support venting ductwork. Replace if cracked or missing.

A replacement LED holder that secures the refrigerator/freezer LED light assembly in the interior liner, keeping the lamp aligned and protected so the interior light stays positioned and functions reliably. What it does:

• Secures and positions the LED light or LED module in the appliance liner
• Protects the LED from direct contact and prevents misalignment or rattling
• Restores proper interior lighting when a cracked or broken holder prevents correct lamp placement
• Works with existing LED lens, wiring, and fasteners to maintain lighting function

• One LED holder

• Disconnect power before accessing the light assembly to avoid shock or shorting the circuit
• Remove the light lens and any retaining screws or clips to access and replace the holder
• Handle the LED and lens carefully; avoid touching LED surfaces and wiring
• Secure fastening before restoring power

Enclosure bracket for microwaves. Secures internal components to the enclosure frame. Replace if bent, cracked, or missing hardware mounting tabs.

Bottom lamp bracket for microwaves. Secures and positions the interior light bulb assembly. Replace if cracked, broken, or missing to properly mount lamp.

This lever is the replacement actuator that lets you operate the dispenser/control function smoothly and reliably. It restores proper engagement when the original lever is cracked, loose, or unresponsive. What it does

• Replaces a worn or broken dispenser/control lever so the dispenser or control mechanism engages correctly
• Helps stop leaks or intermittent operation caused by a cracked or misaligned lever
• Restores firm tactile feel and consistent actuation when pushing or pulling the control
• Useful when the original lever is physically damaged, loose, or has excessive play

• One replacement lever

• Disconnect power or water supply as applicable before starting any repair
• Typically installs with simple clips or screws; may require removing the dispenser front panel or trim
• Handle plastic parts carefully to avoid cracking; test operation before reassembling all panels