General Electric Bumper, Bushing, Grommet Parts

This snap-in plug button is a small decorative cap that covers mounting holes and finishes appliance control panels and trim. It restores a clean appearance and keeps fasteners protected from dirt and moisture. What it does:

• Covers exposed screw holes on control panels, frames or trim to improve appearance
• Helps prevent dirt, grime and moisture from contacting underlying fasteners
• Replaces missing, cracked or worn caps that make panels look incomplete
• Fits into a matching hole and snaps into place for a secure, low-profile finish

• No special tools usually required; press firmly into hole until fully seated
• Check orientation and hole size before installing to ensure proper fit
• If replacing a damaged button, remove any debris or old adhesive from hole
• Disconnect power or follow appliance safety steps if working near electrical components or controls

This mounting spacer keeps exterior panels and components properly separated for correct alignment and fit, helping prevent rubbing and vibration. It's a small, durable replacement used where original spacers have worn or been lost. What it does:

• Maintains correct gap and alignment between panels or assembly parts
• Prevents rubbing, noise, and premature wear from metal-to-metal contact
• Helps secure components in the intended position during operation
• Restores factory spacing after repair or disassembly

• Disconnect power or unplug appliance before servicing
• Replace only with the same spacer location and orientation as the original
• Require removal of trim or panels; keep fasteners and note placement
• If damaged hardware or fasteners are found, replace them to ensure secure fit