General Electric Housing Or Cover

Plastic frame that holds the washer's lint filter in place. Replaces cracked, broken, or missing frames. Installs in the agitator assembly.

This cap clamp secures a wire terminal cap or boot to appliance wiring, helping keep electrical connections stable and aligned for reliable component operation. It's a small but important retainer used where terminal caps are present. What it does:

• Holds a protective cap/boot onto a wire terminal so the cap won't slide off during use or vibration
• Helps prevent loose connections that can cause intermittent operation or arcing at the terminal
• Keeps wiring organized at terminal blocks and component connectors
• Useful when a worn or damaged retainer allows caps to shift or expose metal contacts

• Disconnect power to the appliance before inspecting or replacing wiring components
• Use needle-nose pliers to fit the clamp over the cap/terminal; avoid pinching wires
• After installation, restore power and verify the related component powers and operates normally

Replaces the evaporator fan orifice housing that directs airflow in your refrigerator's freezer section. Needed when original is cracked or worn.

Rear panel that shields your range's internal wiring and components. Replace if cracked, damaged, or missing to protect electronics from dust and heat.

Protective cover that houses the temperature-sensing thermostat on your electric range. Replace if cracked, broken, or missing to protect internal components.

Plastic housing shield that covers and protects the refrigerator dispenser assembly. Replace if cracked, warped, broken, or missing for a secure fit.

Trim panel that covers and protects the control area on your range hood. Replace if cracked, broken, or missing to restore a clean finished appearance.

Housing cover that protects and encloses the dryer heating element assembly. Replace if cracked, broken, or damaged to restore proper dryer operation.

Replaces the outer housing that supports your refrigerator's ice crusher and dispenser chute. Order a new housing if yours is cracked or broken.

Replaces cracked or broken fan orifice housing on your refrigerator. Mounts between the fan motor and interior panel. Essential when old orifice cracks.

This is a formed metal box component used in the ventilation or internal housing assembly of a range or oven. It serves as a structural enclosure that helps direct airflow or protect internal components. Replace this part if it is warped, corroded, or damaged, which can affect proper ventilation or component protection.