General Electric Screws, Nuts, Washers

Mounting screw secures range components and panels. Replace if screw is stripped, missing, or damaged during appliance repair or maintenance work.

Package of 12

Replace stripped, missing, or damaged #8-32 x 1/2 machine screws that secure dryer panels, brackets, and internal components. Restores proper fit.

This plug-in SCR is a solid-state replacement that controls electrical power to appliance circuits, restoring reliable on/off control and helping eliminate intermittent operation. It's a direct-fit replacement when the original SCR fails. What it does

• Regulates current flow in the control circuit to switch power to motors or heating loads.
• Stops erratic cycling or loss of power caused by a failed control semiconductor.
• Helps restore consistent operation when an appliance has intermittent start, no heat, or no motor run.
• Provides a rugged, compact replacement with a 5/16" connection style.

• One plug-in SCR

• Disconnect power to the appliance before accessing or replacing the SCR.
• Remove the appliance's control or access panel to reach the control board; note wire locations before unplugging.
• Plug the new SCR into the original connector or replace per the service manual.
• Verify correct operation after installation and reassemble all panels before restoring power.

Secures the handle to your dryer or microwave door panel. Replace this self-tapping screw if missing, stripped, or damaged to restore a firm grip.

Replacement mounting screw for securing panels, brackets, and components inside your range or oven. Restores proper fit when original is missing or stripped.

Replacement mounting screw for electric ranges and wall ovens. Secures components and panels. Order a new screw if yours is stripped, missing, or damaged.

Secures washer components with a molded sleeve that protects surfaces and reduces vibration. Replace if cracked, worn, or missing to restore secure fit.

M5-16 metric machine screw secures service panels and internal components in washers. Replace missing, stripped, or damaged screws during repairs.

A single replacement screw used to secure appliance panels, trim, and internal brackets so components stay aligned and reduce rattling. Simple, direct-fit fastener for restoring proper mounting and stable operation. What it does:

• Secures panels, mounting brackets, trim pieces and other appliance components
• Helps stop rattling, vibration, or loose panels caused by missing or stripped fasteners
• Restores proper alignment of doors and access panels when original screw is lost or damaged
• Matches the OEM fastening point for a straightforward hardware replacement

• Disconnect power to the appliance before working on electrical components or access panels
• Use the correct screwdriver to avoid stripping the head; match drive type to the screw
• Tighten firmly but do not overtighten—stop when snug to avoid damaging threads or parts
• Keep removed fasteners organized and compare with the replacement to ensure correct fit

Self-tapping screw fastens appliance panels, brackets, and trim by cutting its own thread. Replace missing, stripped, or broken screws during repairs.

Phillips pan head screw for refrigerators. Secures trim panels, brackets, and internal components. Replace stripped, missing, or corroded fasteners.

Stainless steel fastener secures refrigerator door handle to mounting point. Replace if worn, missing, or stripped to fix loose or wobbly handle.

10-32 mounting screw secures range handles and trim pieces to doors or panels. Replace when original hardware is missing, stripped, or damaged.

Truss head screw for fastening oven panels, trim, and brackets. Replace if missing, stripped, or corroded to secure loose components and panels.

Plastic push-in rivet fastener secures trim and panels on electric ranges and ovens. Replace if broken, missing, or worn to prevent loose rattling parts.