General Electric Screws, Nuts, Washers

This small set screw secures components inside your refrigerator. Replacing a missing or stripped set screw restores a tight, reliable hold so attached parts stay aligned and are less likely to loosen or rattle during use.

• Fastens an attached part to its mounting point to prevent movement or slipping
• Helps maintain proper alignment of handles, brackets, or trim pieces
• Reduces wobble, vibration, and rattling noises caused by loose hardware
• Replaces missing, stripped, or corroded set screws

• Unplug the refrigerator and shut off water if working near door/dispenser areas
• Support the part being secured; start the screw by hand to avoid cross-threading
• Tighten with the correct driver for your model; do not overtighten to prevent stripping
• The component is secure and aligned before restoring power

Includes 12 washers.

Secures the drive pulley to the motor shaft in your washer. Replace if worn, loose, or missing to prevent pulley wobble and maintain proper belt alignment.

Secures panels and brackets in your washer. Replace this fastener if lost, stripped, or damaged to restore a tight fit and reduce vibration or rattling.

Replace stripped, missing, or damaged #8-32 x 1/2 machine screws that secure dryer panels, brackets, and internal components. Restores proper fit.

Secures the handle to your dryer or microwave door panel. Replace this self-tapping screw if missing, stripped, or damaged to restore a firm grip.

This silicon controlled rectifier (SCR) is an electronic switching device used to control power to oven/stove heating circuits, helping the appliance regulate temperature and heat output for cooking performance. What it does:

• Switches and regulates AC power to heating elements for controlled heat
• Enables cycle-based or phase-controlled heating used by oven/range controls
• Common replacement when an element won't heat consistently or unit won't maintain temperature
• Helps stop erratic heating caused by a failed power control component

• Disconnect power to the appliance before inspecting or replacing the SCR
• Observe ESD precautions and handle the component by insulated edges

Replacement mounting screw for securing panels, brackets, and components inside your range or oven. Restores proper fit when original is missing or stripped.

Secures and aligns the rear panel on your dryer. Replace this screw if the back housing is loose, missing, or stripped to restore proper panel fit.

Secures the door guide strip to your dryer frame, keeping the door aligned. Replace this nut if it's missing, stripped, or worn to restore proper fit.

M5-16 metric machine screw secures service panels and internal components in washers. Replace missing, stripped, or damaged screws during repairs.

Replaces a damaged or missing M12 x 25 flange bolt in your washer. Secures panels, brackets, and internal assemblies. Needed when bolts are stripped, broken, or lost during repair.

Self-tapping screw fastens appliance panels, brackets, and trim by cutting its own thread. Replace missing, stripped, or broken screws during repairs.

Phillips pan head screw for refrigerators. Secures trim panels, brackets, and internal components. Replace stripped, missing, or corroded fasteners.

Stainless steel fastener secures refrigerator door handle to mounting point. Replace if worn, missing, or stripped to fix loose or wobbly handle.

10-32 mounting screw secures range handles and trim pieces to doors or panels. Replace when original hardware is missing, stripped, or damaged.