Handle

This pocket-style door handle provides the recessed grip used to open and close the appliance door. Replacing a cracked or missing handle restores a clean look and a secure, comfortable grasp for everyday use. What it does:

• Provides a built-in finger pocket for reliably opening and closing the door
• Replaces a broken, cracked, loose, or missing handle
• Helps resolve difficulty gripping the door or sharp/rough edges from damage
• Maintains proper look and prevents stress on adjacent trim or panels

• 1 pocket-style door handle

• Disconnect power to the appliance before servicing.
• Open the door and remove the screws/clips retaining the old handle; note orientation and placement.
• Reuse the existing fasteners/brackets as required and align the new handle carefully.
• Tighten fasteners snugly without overtightening; verify smooth door operation.

Color: white. It measures about 16 inches wide by 2 inches high by 2 inches deep.

This is a white replacement handle assembly that restores a solid, comfortable grip and fresh appearance to your appliance. Use it to replace a cracked, loose, or missing handle so doors or drawers open and close smoothly.

• Provides the rigid handhold used to open and close the appliance door or drawer
• Helps resolve a loose, broken, or missing handle
• Can improve operation when the door is hard to open due to a damaged handle
• Refreshes the look of the appliance after cosmetic wear or discoloration

• Disconnect power before servicing
• Open the door to access mounting fasteners; retain and reuse original screws and any trim caps
• Transfer any spacers or brackets from the old handle to the new one
• Align carefully and tighten fasteners evenly—do not overtighten

Color: White

This handle trim replaces a damaged or missing trim piece on the appliance's door handle. It restores a clean, finished look by covering mounting hardware and helps keep the handle properly aligned for everyday use.

• Finishes the end of the door handle and hides visible screws
• Helps stabilize the handle and maintain proper alignment
• Restores appearance when the original trim is cracked, loose, or missing
• Common signs: broken or missing cap, exposed screws, wobbly handle

• Disconnect power before servicing
• Open the door to access the handle; remove the old trim by releasing its clips or fasteners
• Align and snap the new trim into place; transfer any hardware if required
• Do not overtighten fasteners to avoid damaging plastic parts

This replacement handle restores a secure, comfortable grip for opening and closing your appliance door. It replaces a cracked, loose, or missing handle so operation feels normal again and the appliance maintains a clean, finished look.

• Provides a sturdy handhold to pull/push the door during everyday use
• Attaches to existing mounting points on the door
• Common symptoms: cracked or broken handle, looseness, missing handle, difficulty opening the door
• Helps return the appliance's appearance to like-new condition

• Disconnect power to the appliance before starting; allow hot surfaces to cool
• Wear cut-resistant gloves; support the door/handle while removing hardware
• Reuse existing screws/end caps as applicable; start all fasteners before tightening
• Tighten evenly without overtightening; verify smooth door operation after installation

This replacement latch secures the door closed so the appliance can operate correctly. Restores a positive close and consistent door recognition to help prevent no-starts and intermittent operation. What it does / common symptoms:

• Engages the strike to hold the door/panel closed
• Ensures the door-closed signal is made so controls can run
• Worn or broken latch may cause the door not to stay shut
• Unit may not start, show a "door" message, or stop if the door is bumped

• 1 latch

• Disconnect power before servicing; turn off water supply if applicable
• Access the latch per model—typically behind the front panel or inner door liner
• Note and transfer any springs/clips from the original latch to the new one
• Verify smooth open/close and proper strike engagement before testing operation

This black oven door handle restores a secure grip and clean look to your appliance. Replace a cracked, loose, or missing handle to safely open and close the oven door.

• Provides the handhold used to open and close the oven door
• Replaces damaged or missing handle to restore normal operation
• Helps address a loose, wobbly, or sagging handle
• Refreshes the door's appearance when the old handle is scuffed or broken

• Disconnect power at the breaker; for gas units, shut off gas. Allow the oven to cool completely.
• Remove the door or inner panel per your model's manual to access the handle mounting screws.
• Support the outer glass/trim while removing and installing hardware to prevent damage.
• Tighten mounting screws evenly and verify smooth door operation before use.

Color: Black

Color: Black

This handle assembly attaches to the storage drawer on a laundry pedestal, providing a solid, comfortable grip. Replace a cracked, loose, or missing handle to restore smooth drawer operation and the pedestal's original, finished appearance.

• Mounts to the pedestal drawer front and serves as the user pull
• Helps ensure consistent, easy opening and closing of the storage drawer
• Typical failure symptoms: cracked or broken handle, loose handle, difficulty opening the drawer
• Restores proper fit and appearance after damage or wear

• Disconnect power and remove drawer contents before beginning
• Remove the drawer to access the handle fasteners; place it on a protected surface
• Remove fasteners, align the new handle, and secure; reuse existing hardware if in good condition
• Test drawer operation and avoid overtightening screws

Color: Bisque. For white order WP74011768. For black order WP74011767. For screws order WP74006515.

This white door handle replaces a broken or loose handle to restore a secure, comfortable grip when opening and closing the appliance door. It refreshes the look of your unit while returning everyday usability.

• Provides a sturdy handhold for opening and closing the door
• Direct replacement for cracked, broken, or missing handles
• Helps if the handle flexes, feels loose, or mounting points are damaged
• Restores the original appearance with a matching white finish

• Disconnect power before beginning any repair
• Protect the door/glass; access the handle's mounting screws
• Reuse existing fasteners/trim; align the handle and tighten screws evenly without overtightening
• Test door operation to ensure a secure fit

This handle insert fits into the handle assembly to cover mounting hardware and complete the finished look. Replace a missing or cracked insert to restore appearance and help protect the hardware underneath.

• Press-fits into the handle to conceal fasteners and provide a clean, finished appearance
• Helps keep debris out of the handle cavity and around screw heads
• Typical symptoms: insert broken or missing, exposed fasteners, rough or sharp handle opening edges

• Disconnect power before servicing; wear gloves to protect hands from sharp edges
• Carefully pry out the old insert with a plastic tool to avoid marring surrounding surfaces
• Align the new insert with any tabs/slots and press evenly until fully seated
• Tighten screws beneath the insert before installing the new piece

The Spacer is an OEM part for Frigidaire ranges and ovens. This part provides the necessary clearance between the oven door handle and the door itself, preventing friction and wear while ensuring the handle is securely attached and easy to use. This small but crucial component aids in the proper functioning of the oven door, making it easier and safer to open and close without exerting extra force.

Causes of a bad Spacer include mechanical stress leading to cracks or breaks, improper installation that may result in loosening over time, and degradation from heat exposure and frequent use.

Symptoms of a failing Spacer include:

• Loose oven door handle.
• Difficulty in opening or closing the oven door.
• Visible gaps or misalignment of the door handle.

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

A white replacement handle assembly that restores a clean, functional door grip and appearance. Installs in place of a cracked, broken, loose or worn handle to make opening and closing smooth and secure. What it does:

• Replaces damaged or worn door handle for reliable grip and operation
• Restores original appearance on white finishes
• Stops cracking, splitting or loose-handle symptoms that affect use
• Matches OEM mounting points for a secure fit when installed correctly

• Disconnect power or unplug the appliance before servicing if your repair requires access near electrical components
• Use basic hand tools; follow OEM diagram for fastener locations and alignment
• Tighten fasteners securely but avoid overtightening to prevent cracking