Hinge Parts

Ordered the full hinge piece and an extra bushing. Was able just to slide the dishwasher forward a bit, lift the right side hinge off its seat and pop in the new bushing without disassembling. Fixed! I am retaining the full hinge piece in case of any future door incident but suspect I will never need it Read more

Replaced these parts Read more

My Whirlpool refrigerator model GSS26C4XXF03 door wouldn’t swing shut all the way like it used to. So I changed the two lower cams. This cam #WPW10257203 was a perfect match but I needed to change the matching cam on the hinge, also, which require some modification to fit (I ordered cam #W11311687). The whole thing would have taken less than 15 minutes if I didn’t have to modify the other cam. Read more

The right door on our Jenn Air French Door Refrigerator would pop open & not fully close when the left door was closed first. Called the local distributor/dealer who advised me that the magnetic door gasket probably needed replacement (cost $300.00 + for the repair) What??? Visited you web site where I noted the right door had a "closure & bushing" on the bottom of the door. Could it be this was the problem fix? Took the right door off & examined both pieces. Sure enough the bushing was... Read more

Looked at web site, but I was not sure I was ordering the correct parts. I did an on line chat . It was great only 3 minutes and I had the parts on the way . Super easy . Needed door hinge. Read more

Ordered the parts from AppliancePartsPros after another outlet had me on back order. The parts arrived and I installed them. We now are using our freezer. Read more

Replaced upper and lower thimble's, lever arm, cam closure. Door stop was not the problem, but ordered it and replaced it too. The door of course has to come off, remove the top hinge, and lift it away. Lubricated moving parts with silicone spray. Be sure and put the door back in the open position, so the lever arm and cam closure can properly interact, then close the door. Remove the plastic grate at the bottom to get at the lever arm. Presto. Problem gone. Don't put excessive weight... Read more

Replacement of hinges and door seal. Read more

Replaced door closure and door stop. Read more

I ordered the door stops (or door cams) for both the fridge and freezer and the hinge bearings. I figured I might as well do both if I'm going to do one. Very easy. Watched a YouTube video. Got a link to the site to order the parts. All you need is a screwdriver and ratchet. Done in 30 minutes. Read more

Looked up parts on internet using diagrams, ordered parts, they arrived in 2 days and installed them. Read more

Watched your very helpful and informative "how to" video and replaced both right and left hinges. Getting the front panel to line up on the clips was the most difficult part. Read more

Replaced both sets of door cams on my Kenmore Elite Refrigerator. The most important thing to know is that you DO NOT have to remove the doors from the refrigerator to replace BOTH sets of cams. You just have to remove the lower grill which is a snap fit (I also turned off the water and unplugged the unit). My fridge has an ice and water dispenser where the water and electrical lines go through the cams on the left side. Be sure to order the correct parts as the cam holes on the freezer side... Read more

Put the new hinges on the doors fyi you need to tell what size the screws are for the hinge kits would help a lot Read more

• Door won't close

Purchased parts from your company with the help of your people Read more