Need Help?
Call or text
Secures the inner door gasket to prevent water leaks during wash cycles. Replace if gasket is loose or leaking. Confirm fit with your model number.
The upper counter-balance weight mount design is a poor design to begin with. It started to rattle loose approximately 5yrs into the 8yrs that we've owned it. As it would start to loosen up (as evidenced by the loud banging noise exhibited during operation); I'd shut it down, pull the top off, remove the weight (it was almost always half rattled off at this point), wrap the mount lugs with friction tape (the plastic lugs were being worn down/chaffed by the balance weight), put the weight back... Read more
The Door Seal is an OEM part for LG dryers. It forms a tight seal around the dryer door, preventing heat and moisture from escaping during the drying cycle, which ensures efficient drying and energy use.
Causes of a bad door seal can include wear and tear from regular use, damage from repeated opening and closing of the dryer door, or degradation from exposure to heat and moisture over time. A compromised door seal can lead to longer drying times and increased energy consumption.
Symptoms of a bad door seal include:
This OEM LG part is also compatible with Sears/Kenmore.
Ordered and installed replacement seal Read more
Exhaust damper for microwave venting systems. Installs on rear exhaust to regulate airflow. Replace if cracked, broken, missing, or not sealing properly.
Needed installation parts. I ordered the parts from the company I purchased the appliances from. A week went by and no parts, called, emailed and called again to find out when the parts would arrive to be able to Re-schedule the installation. After the run around, I found AppliancePartsPros website and placed my order with them. I received the parts I needed within the time they promised. I was able to schedule my installation to enjoy my new appliance. It's been almost 4 weeks and still no... Read more
Hinge assembly for refrigerator doors. Installs at door pivot point to support door weight and enable smooth opening/closing. Replace if cracked or worn.
There is one hinge on top and one at the bottom, but it was none of these it ended up being this hinge that I ordered. Door was having a little hesitation at closing, the door would not pull your hand to close or it would not closed by itself. replaced this part and the refrigerator was fixed. Read more
Plastic bracket that holds the lint filter in place and also serves as the mounting point for the moisture sensor on some models. 8.1 inches long.
We called a repairman out who was rude, obnoxious and seemingly incompetent. After an hour of dissembling our dryer, he quickly slapped it back together and told us it would be $200 to fix. No other explanation. We sent him on his way and I found your site, found the ($5) part and watched the 5 min repair video. Ordered the part and had it in our hands in less than 48 hours. I had the dryer repaired in 20 min. Saved us a lot of money and made me feel pretty good about my own normally meager... Read more
Covers and protects the dispenser area on your refrigerator. Replace if cracked, broken, or scratched from repeated use and moisture exposure.
Very helpful video from a link on your website (https://www.youtube.com/watch?v=EBIv0bxEhkE), and saved me a major repair bill. My journey started with an effort to replace just the water dispenser button, which failed because the fifth post on the back side of the button (not the four posts which hold the button in place--it's the extra rectangular piece visible near the repairman's pinkie finger at 3:04) had broken off, and it is this piece which reaches and moves the actuator for the water... Read more
Ice maker stopped making ice or water dispenser not working? This water inlet valve controls water flow to your refrigerator. DIY-friendly repair.
I called Appliance Parts Pros and talked to you, a customer care service person Whitley, which help me out real good in finding the right part I needed. She was very very helpful and knowledgeable. Read more
Washer won't spin or shows LE error code? The stator assembly converts power to spin the drum. Moderate repair, typically takes 30-60 minutes with video.
Swapped bad part for new part. Read more
Traps lint and debris during drying cycles to maintain airflow and prevent vent clogs. Replace when torn, damaged, or no longer catching lint effectively. Verify fit with your dryer model number before ordering.
I ordered a new lint filter assembly. Read more
The Ice Chute Door is an OEM part for LG refrigerators. It is located in the ice dispenser area on the front of the refrigerator. It opens and closes automatically when ice is dispensed, ensuring a controlled release of ice cubes or crushed ice into the user's glass or container. The door helps to prevent frost buildup, maintain proper insulation, and protect the ice inside the dispenser.
Causes of a faulty ice chute door can include wear and tear over time, damage due to regular use or accidental impact, or a malfunctioning door motor or solenoid.
Symptoms of a bad ice chute door may include:
This OEM LG part can also be used on Kenmore/Sears appliances.
The ice chute flap wasnt closing. 1. I turned off power 2, Pulled off facia around controls on freezer door,, you have to pull out the bottom part of the chute first , its clipped in 3. Disconnected the front panel 4. Unscrewed the next panel to allow access to the chute flap 5. Removed 1 screw holding complete flap and mechanism and replaced with new 6. Re installed all parts in reverse Problem was the chute flap had worn and was folding over on top edge when opened and then wouldnt return... Read more
The Convection Fan Motor is an OEM component for LG stove tops and ranges. It refers to the small electric motors used within certain LG gas or electric range models.
Causes of a faulty cooking range motor include normal wear from years of operation in high-heat environments. Grease and food deposits can also impair motor performance over time.
Symptoms of a bad motor include:
Ordered a new convection fan motor and blade. Had to remove current blade from inside oven, then remove back panels (yes, it took two to get to the fan motor), and replaced the motor. Old motor well past shot. Had been noisy for about 3-4 weeks, but our kitchen was being remodeled, so we let it slide. Once it was clear how to remove back panel, the job was easy. Took about $100 and 2 hours of my time, but the oven convection fan is running silently again. Have not installed the new fan... Read more
Refrigerator not cooling but freezer works? Compressor not starting? The start device provides electrical power to start the compressor. Basic repair.
Cover that fits over the dryer's lint filter duct area. Replace if cracked, broken, or missing to keep items from falling into the duct when filter is removed.
The original issue with the dryer is that a corner of the lint screen was sticking out of the lint screen guide, and it would not stay flush with the guide. As a result, many tank top straps, waistband strings, and blankets would get caught on this corner and twist, tear, or warp my clothes. When I did my research on the issue, I kept reading that it was an issue with the lint screen that came with the dryer. So I ordered the lint screen, guide, and cover that appliance part pros recommends to... Read more
Dryer door hinge connects the door to the cabinet frame. Replace if cracked, broken, or worn causing misalignment or door sagging. Installs with 3 screws.
I took out 3 screws and replaced the part and it took maybe 1 minute. I only needed a screwdriver. Works great and I am very happy it is fixed but not about doing more laundry. Read more
Suspension rod kit for washers. Supports the drum and reduces vibration during wash and spin cycles. Replace when rods are broken, worn, or damaged.
One of the suspension rods was not working so I replaced the bad one and the other three . Tub has now leveled out and is spinning properly without making the noise. Have not needed to replace the pump but will do so if necessary. Thanks to Appliance Parts Pro for their prompt service and quality products. Read more
Ice maker not filling or overflowing? Water dispenser not working? This water inlet valve controls flow to your ice maker and dispenser. DIY fix in 30 min.
I read the Q&A on this website to determine which part I needed, the ice maker was overflowing not leaking, so I ordered the valve and within a day it arrived. Read more