Search Results

Connects the drive motor to the auger to rotate the blade and move snow. Replace if stretched, slipping, or causing poor snow pickup. Verify fit with your model.

This drive belt is made for use on lawn mowers produced by multiple manufacturers. This belt attached the motor to the blade. This causes the driveshaft to rotate the blade. Because these belts are made of rubber, normal wear tear causes deterioration over time.Deterioration can take the form of cracking, tearing, or stretching of the drive belt. This can cause a complete breakdown of the lawn mower or reduced performance. If the mower is acting sluggish, it may be time to check the belt and replace it if necessary.Before removing and replacing the belt, it is important to drain the fuel tank and remove the spark plugs to ensure safety. Always disengage the blades and wear gloves when replacing the drive belt. After removing the damaged belt, slide the new belt on and reinstall the spark plug before operating the mower.This drive belt is OEM sourced. It is an individual part designed for use with edgers made by Troy-Bilt, Yard-Man, Yard Machines, Cub Cadet, and MTD.

Replace your lawn vacuum belt when you notice slipping, cracking, or reduced performance. This 1/2 x 26 inch V-belt restores power transfer. Verify fit with your model number.

Forward drive belt for rear-tine tillers. Replace when you notice slipping, cracking, or loss of power transmission. Verify fit with your model number.

Tiller belt that drives the tines for soil cultivation. Replace when worn, cracked, or slipping to restore proper tilling performance. Verify fit with your tiller model number before ordering.

Replace your chipper shredder's V-belt when you notice slipping, cracking, or reduced performance. Ensures proper power transfer to cutting blades. Verify fit using your model number before ordering.

This is a genuine replacement belt designed to work with multiple types of snowblowers. It is sometimes called a wheel drive belt or a V-belt. The belt is installed on pulleys that allow the transfer of motive power from the engine to the wheels and the auger, allowing the snowblower to move forward, as well as break up and throw snow. These belts are made from high-quality rubber, but they will suffer from wear and tear over time. Through normal use, exposure to extreme temperatures, and over time, the rubber can crack, and eventually, the belt will break. If the snowblower's wheels will not turn, it is most likely that the belt needs to be replaced. Replacing the belt is simple, but will require accessing the pulleys. Remove the old belt and then install the new one according to the owner's manual. Note that this is an OEM replacement part and is sold individually. It is designed for Craftsman and MTD snowblowers, as well as models from Ryobi, Huskee, Cub Cadet, Yard Machines, Yard-Man, and Troy-Bilt.

Experts agree that snowblower belts typically last from five to seven years, depending on how hard the machine is used each season and the overall conditions. This OEM replacement drive belt is designed to perform to the same standards as factory installed belts. Making the repair is relatively straightforward and requires the removal of the upper belt guard. From there, access to the pulleys is possible and an extension bar along with a ratchet and socket are necessary for the repair. The next steps vary based on model. This belt works with Snapper, Simplicity, Murray, Briggs & Stratton, among other snowblower makes and models. It ships individually.