General Electric Bracket & Flange

This solenoid saddle is a small mounting bracket that secures a refrigerator solenoid in the correct position. By preventing movement and misalignment, it helps the linked mechanism engage smoothly and consistently.

• Secures the solenoid to its housing or frame to prevent shifting
• Maintains proper alignment for reliable actuation
• A worn or broken saddle can cause buzzing/chattering and intermittent operation
• Restores stable mounting to help the connected mechanism work correctly

• Disconnect power; shut off water supply if working near water lines
• Access the solenoid assembly and note the original saddle's orientation
• Transfer the solenoid into the new saddle and reuse existing fasteners/clips
• Smooth operation before reassembling panels

Wall-mounted safety bracket that prevents range tip-over. Includes bracket, screws, and instructions. Replace missing or broken brackets required by code.

Secures the evaporator fan motor to the refrigerator cabinet. Replace if your original bracket is bent, broken, or cracked to restore proper mounting.

Secures the rear drum bearing to keep your dryer drum aligned and rotating smoothly. Replace if bracket is cracked, bent, or worn to restore proper support.

Replaces the rear mounting bracket that secures a leveling leg to your dryer frame. Needed when the original bracket is cracked, broken, or missing.

The microwave switch lever is a small plastic arm inside the door latch assembly that activates the door interlock switches when the door is closed. These switches signal the microwave that the door is securely shut before allowing it to operate. Replace this part if the microwave won't start, runs with the door open, or the door doesn't latch and release properly.

Secures the igniter assembly to your range burner system. Replace this bracket if it's bent, broken, or missing to properly mount the igniter component.

Metal bracket that secures the gas orifice in place on your cooktop. Replace if bent, broken, or missing to properly mount the orifice assembly.

Hinge grille bracket for microwaves. Mounts behind the door hinge area to secure the grille panel. Replace if cracked, broken, or missing for proper fit.

Mounting bracket for over-the-range microwaves. Secures unit to cabinet or wall. Replace if bent, cracked, or missing to ensure safe installation.

Replacement mounting bracket that secures internal panels to the frame. Install this bracket if your original is cracked, bent, or missing.

Door lever for microwave ovens. Installs on the door latch assembly to operate the release mechanism. Replace if broken, cracked, or missing.

Metal angle support bracket that secures interior panels, shelves, or trim inside your range. Replace if cracked, bent, or missing to maintain proper alignment.

Mounting bracket that secures the radiant element to your cooktop. Replace if bracket is bent, broken, or missing to properly support the heating element.

Mounting bracket for range installation. Secures appliance to cabinet or wall. Replace if bent, broken, or missing during installation or relocation.