General Electric Bumper, Bushing, Grommet Parts

Teflon cushion for microwaves. Installs as a protective buffer between moving parts. Replace if worn, cracked, or missing to prevent friction damage.

Range spacer component installs between parts to maintain proper clearance and alignment. Replace if cracked, broken, or missing to restore fit.

Spacer that fits behind oven door handles to ensure proper alignment and fit. Replace if cracked, missing, or worn to restore a snug, finished appearance.

Plastic clip plug that secures the outer case panel on your microwave. Replaces broken, cracked, or missing clips to properly fasten cabinet panels.

Rubber grommet seals the cabinet opening where a gas valve or hose passes through your cooktop. Replace if cracked, torn, or missing to restore seal.

Rubber cushion that mounts between the air conditioner motor and housing to reduce vibration and noise. Replace if cracked, compressed, or missing.

Replaceable trim grommet that caps the end of your refrigerator door handle. Replaces cracked, broken, or missing caps for a finished look and secure fit.

Rubber push-in grommet that cushions where the refrigerator door contacts the cabinet. Replace if worn, cracked, or missing to prevent scratches.

Replacement .060 shim for refrigerator door alignment. Installs between door and cabinet to ensure proper spacing and seal. Needed when worn or missing.

Refrigerator evaporator door bumper cushions the door as it closes. Replace if cracked, broken, worn, or missing to protect door components.

This lid bumper cushions the lid of your top-load washer as it closes, absorbing impact to reduce slamming noise and protect the top panel's finish. Replace a worn or missing bumper to restore smooth, quiet lid operation. What it does

• Absorbs impact between the lid and cabinet to reduce slamming and vibration noise
• Helps protect the top panel finish from chips and scratches near the lid area
• Restores proper cushioning when the original bumper is missing, cracked, or flattened
• Common symptoms: lid slams or clunks when closing, increased noise, visible missing bumper

• 1 lid bumper

• Disconnect power before servicing
• Open the lid and pull the old bumper straight out of its mounting hole; needle-nose pliers can help if it's stuck
• Clean the hole and surrounding surface for a secure fit
• Press the new bumper fully into the hole until seated flush; for even cushioning, consider replacing both if your model uses two

Replacement compressor cushion for air conditioners. Absorbs vibrations and reduces operational noise. Install when original is cracked or worn out.

Secures and isolates the power control module from the range chassis. Replace if cracked, broken, or missing to maintain proper spacing and stability.

Replacement door hinge bushing for laundry centers. Restores smooth pivot operation when original is worn, cracked, or causes door misalignment or sticking.

Replace a cracked, worn, or missing bumper on your range. This protective bumper cushions and prevents surface damage where components meet or move.