General Electric Bumper, Bushing, Grommet Parts

Rubber grommet that cushions and protects refrigerant or water tubing where it passes through sheet metal. Replace if cracked, worn, or missing.

Replacement .060 shim for refrigerator door alignment. Installs between door and cabinet to ensure proper spacing and seal. Needed when worn or missing.

Refrigerator evaporator door bumper cushions the door as it closes. Replace if cracked, broken, worn, or missing to protect door components.

This lid bumper cushions the lid of your top-load washer as it closes, absorbing impact to reduce slamming noise and protect the top panel's finish. Replace a worn or missing bumper to restore smooth, quiet lid operation. What it does

• Absorbs impact between the lid and cabinet to reduce slamming and vibration noise
• Helps protect the top panel finish from chips and scratches near the lid area
• Restores proper cushioning when the original bumper is missing, cracked, or flattened
• Common symptoms: lid slams or clunks when closing, increased noise, visible missing bumper

• 1 lid bumper

• Disconnect power before servicing
• Open the lid and pull the old bumper straight out of its mounting hole; needle-nose pliers can help if it's stuck
• Clean the hole and surrounding surface for a secure fit
• Press the new bumper fully into the hole until seated flush; for even cushioning, consider replacing both if your model uses two

Secures and isolates the power control module from the range chassis. Replace if cracked, broken, or missing to maintain proper spacing and stability.

Positions and supports oven door glass to maintain proper alignment. Replace if worn, cracked, or missing to prevent glass rattling and gaps.

Replacement door hinge bushing for laundry centers. Restores smooth pivot operation when original is worn, cracked, or causes door misalignment or sticking.

Replace a cracked, worn, or missing bumper on your range. This protective bumper cushions and prevents surface damage where components meet or move.

Bezel bushing for gas ranges and cooktops. Installs on the control panel bezel to provide support and spacing. Replace if cracked, broken, or missing.

Spacer for range hood installation. Provides proper spacing and alignment between hood components. Replace if cracked, broken, or missing during assembly.

Plastic bumper that cushions and protects freezer baskets from scratching interior walls. Replaces worn, cracked, or missing bumpers. Installs on basket edge.

Freezer drawer slide shim for bottom-mount refrigerators. Replaces worn, cracked, or missing shims that support smooth drawer operation.

Spacer for electric ranges. Installs to maintain proper clearance between components. Replace if cracked, worn, or missing to restore correct spacing.