General Electric Clip Or Clamp

This wire clip secures appliance wiring and harnesses to the cabinet or chassis to prevent movement, chafing, and accidental contact. It helps maintain reliable electrical connections and reduces risk of shorts or wire damage. What it does:

• Holds wiring and harnesses in place to prevent rubbing, pinching, or contact with hot/moving parts
• Reduces strain on connectors to help prevent intermittent electrical issues
• Keeps wiring routed neatly for safer, more reliable operation
• Helps prevent shorts and abrasion-related failures

• Disconnect power before starting any repair to avoid shock or damage
• Remove panels as needed to access the clip mounting location
• Clip typically snaps into a preformed hole or slides over the wire/harness; use pliers if needed for removal/installation
• Replace any damaged wiring or insulation found during installation

This grinding ring is the wear surface for the appliance's grinding assembly, replacing a worn or damaged ring to restore normal grind performance and reduce noise from metal-on-metal contact. What it does

• Serves as the replaceable wear surface inside the grinding chamber
• Helps maintain proper clearance between grinding components
• Commonly replaced when you hear excessive grinding noise or reduced grinding efficiency
• Can prevent further damage to mating grinding parts by restoring proper contact surfaces

• One grinding ring

• Disconnect power to the appliance before starting any disassembly
• Removal requires partial disassembly of the grinding chamber; follow the OEM service manual
• Use gloves and eye protection to avoid sharp edges and debris

This Ring "E" trim ring is a small OEM appliance replacement that secures and protects adjacent components, helping maintain proper alignment and reduce wear. It restores correct fit where the original ring is cracked, warped, or missing. What it does:

• Holds nearby trim or sealing parts in place to prevent rubbing and misalignment
• Helps maintain an even seal and component spacing that supports normal operation
• Commonly replaced when the original ring is broken, deformed, or lost during service
• Does not change appliance function by itself but prevents related cosmetic and fit issues

• One Ring "E" trim ring

• Install only on the specified location shown in the appliance parts diagram; verify orientation before fastening
• Use basic hand tools; avoid over-tightening fasteners that could crack the ring
• Disconnect power (and shut off water if applicable) before servicing nearby components
• If other parts show damage, inspect adjacent seals, clips, or trim for concurrent wear

This 1.25 in. diameter clamp secures hoses and tubing on appliances to help prevent leaks and keep connections tight. Simple, durable design for restoring a secure hose connection and stopping water loss or spray. What it does:

• Holds flexible hoses or tubing firmly to a barb or fitting to maintain a watertight seal
• Commonly used on water inlet, drain or circulation hoses where a snug clamp is required
• Helps address symptoms like leaking connections, loose hoses, or intermittent drips
• Works with compatible 1.25 in. hose diameters for reliable clamping force

• Disconnect power and shut off water supply before replacing clamps on plumbing connections
• Match clamp size to hose diameter and position over the barb or fitting before tightening
• Use appropriate hand tools and avoid over-tightening to prevent hose damage
• Inspect surrounding hoses and fittings for wear; replace any damaged components for a long-lasting repair