General Electric Clip Or Clamp

Secures trim panels and wire harnesses in your top-mount refrigerator to prevent noise and component wear. Replace if loose, cracked, or missing.

Secures temperature sensor in place for accurate readings. Replace if loose, cracked, or sensor reads incorrectly. Confirm fit with your model number.

This small terminal pin connects a wire to an appliance's electrical terminal, restoring a secure electrical connection so components receive reliable power and operation. Ideal for repairing loose or damaged wire terminations. What it does:

• Provides a secure metal contact point for a wire at a terminal or connector
• Restores proper electrical continuity when a terminal end is worn, bent, or broken
• Helps eliminate intermittent power, arcing, or component failures caused by poor connections
• Used wherever a single-pin wire termination is required on the appliance harness

• Disconnect power before servicing to avoid shock or injury
• Remove the damaged terminal and ensure the replacement pin matches shape and size
• Crimp or seat the pin per OEM guidance; ensure a snug, corrosion-free connection
• If wiring or harness insulation is damaged, replace the harness

Secures and organizes wiring harnesses inside your dryer. Replace if wires are loose, vibrating, or damaged. Confirm fit with your model number.

A small metal C-shaped retaining clip that secures shafts, pins or components in place to prevent unwanted movement. Simple, durable hardware that restores proper fit and alignment for the part it secures. What it does:

• Holds shafts, pins or rods in position to prevent axial movement or disengagement
• Restores secure attachment where a worn or missing clip allows parts to shift or fall out
• Used in moving assemblies to maintain alignment and proper function
• Fits in a groove or slot and provides spring tension for a tight hold

• One C-clip (retaining clip)

• Inspect the mating groove/pin for burrs or damage before installing the clip
• Use appropriate snap-ring or pliers to compress/expand the clip as needed; wear eye protection
• Ensure the clip fully seats in its groove and that the retained component moves as intended

Secures wiring and hoses in your laundry center to prevent rubbing and wear. Replace when broken or missing to maintain proper routing. Verify fit.

Retaining clamp secures hoses and tubes to prevent leaks and loose connections in your washer dryer combo. Replace if worn or damaged. Verify fit with model.

Secures front panel on laundry centers. Replace if broken or panel becomes loose. Verify fit with your model number before ordering this clip.

Secures compactor panels and trim to the cabinet frame. Replace when mounting hardware is worn, broken, or causing rattling. Confirm fit with your model.

Secures shafts, hoses, and components in your trash compactor to prevent movement or separation. Replace if loose, damaged, or parts shift during operation. Confirm fit with your model number.

Oven clip secures components in place during operation. Replace if broken, loose, or missing to prevent rattling and ensure proper part alignment.