General Electric Control Board

A replacement frame board assembly that secures the oven/range control console and gives the control area a finished appearance. Restores proper mounting and protection for the control electronics so buttons and displays sit correctly. What it does

• Provides the structural frame and mounting surface for the range/oven control console and control board.
• Protects control electronics and wiring from exposure and interference.
• Keeps front control buttons, switches and displays aligned and stable.
• Restores the unit's finished appearance when the original frame is cracked, bent or broken.

• Disconnect power to the appliance before starting work to prevent shock or damage.
• Handle sharp sheet-metal edges carefully and keep small fasteners organized for reassembly.
• Some disassembly of the backguard or control console may be required to access mounting screws.

Fix a non-responsive oven display, dead keypad, or heating failure with this electronic control board. Restores timed bake cycles and temperature control.

Fix range burners not heating or oven temperature issues with this relay daughter board assembly. Controls power distribution to heating elements.

Fix unresponsive controls, display errors, or oven not heating with this range control board. Moderate difficulty repair requiring basic tools.

This filter board is the electronic control board that monitors and communicates your refrigerator's filter status and related dispenser signals, restoring proper filter detection and indicator operation. What it does

• Monitors filter presence and communicates filter status to the display or dispenser
• Sends/receives signals that enable filter-related indicator lights and alerts
• Helps restore dispenser/filter indicator functionality when the original board fails
• Common symptom: filter status light stays on or does not change after replacing the filter
• Common symptom: dispenser or filter indicator behaves intermittently or not at all

• Disconnect power to the appliance before starting service to avoid shock
• Handle the board by the edges and avoid touching contacts; protect against static discharge
• Access typically requires removing the dispenser/display or control housing—retain screws and mounting hardware

This right-side generator board is the replacement control board that completes the unit's ignition/control circuit, restoring proper operation and reliable starts. Use it to replace a damaged or non-responsive right-side generator board. What it does:

• Routes ignition/control signals to the right-side components and helps enable proper spark or control functions
• Common symptom: no ignition or intermittent starting on the right side
• Common symptom: erratic or no response from the affected side's controls
• Helps restore normal operation when the original board is cracked, burnt, or electrically damaged

• Disconnect power (and gas, if applicable) before starting any repair
• Handle the board by the edges and avoid static discharge; use ESD precautions if available
• Inspect connectors and wiring for heat or corrosion; replace damaged wiring or connectors

Touch control circuit board for 30-inch cooktops. Replace this electronic control panel if buttons are unresponsive, cracked, or display is damaged.

Generator control board for cooktop center module. Replaces cracked, damaged, or malfunctioning circuit board. Mounts inside cooktop control assembly.

Touch control board mounts behind the touchpad interface on electric cooktops. Replace if controls are unresponsive, locked, or buttons fail to register.

Left-side generator module circuit board for cooktop ignition control. Replaces damaged, non-functioning, or corroded modules. Installs on left burner.

Fix unresponsive buttons or a non-functioning control panel with this range hood control board. Restores full electronic operation and settings.