General Electric Control Board

This relay board assembly routes power to the appliance's compressor and fans so cooling cycles and motor functions run correctly. Replacing a failed relay board restores proper power switching without replacing major components. What it does

• Switches power to compressor and condenser/evaporator fans through relay contacts
• Enables start/run sequences for motors and compressors
• Common symptom: appliance not cooling or cooling inconsistently
• Common symptom: loud clicking, repeated start attempts, or compressor/fans not running
• Works as the electrical switching module tied to the main control/relay system

• Disconnect power before servicing to avoid shock or damage
• Handle the board by edges and avoid ESD-sensitive contact with components
• Verify connector fit and orientation before powering up

This main display board replaces the console control module that shows time, oven temperature, and cycle status so the oven's display and touch controls work properly. Restores visible readouts and control responsiveness. What it does:

• Powers and drives the front display and electronic touch/sensor controls
• Updates clock, cook settings and cycle status shown on the console
• Helps resolve issues like blank or flickering display, incorrect readouts, or unresponsive touch controls
• Works with the console wiring and user interface to relay commands to the oven control system

• One main display (console control) board

• Disconnect power at the breaker before starting any repair
• Handle the board carefully to avoid static damage; use anti-static precautions if available
• Remove the console/faceplate per service instructions to access the board; keep screws and connectors organized
• Verify wiring connectors match and seat fully before restoring power; test functionality after reassembly

This OEM electronic oven control (ERC3HP) manages your range's timing and cooking functions to restore normal oven operation and user-interface control. It replaces the main control assembly for models that use the ERC3HP module. What it does:

• Controls oven bake, broil, and timer functions so the oven responds to user commands
• Manages clock and display logic to show time and settings
• Restores normal electronic control when the original ERC is unresponsive or shows interface errors
• Stops symptoms like unresponsive touchpad, incorrect cycle behavior, or blank/erratic display

• One oven electronic control (ERC3HP) board

• Disconnect power to the appliance at the breaker before starting any repair
• Handle the control board carefully and avoid touching circuit traces or components
• Some disassembly (back panel or console) is required; keep track of screws and connectors

This electronic oven control replaces the oven's main control board to restore timed bake/clean cycles and oven temperature control. It helps recover lost display, non-responsive keypad, or heating problems caused by a failed control. What it does:

• Replaces the oven's electronic control module that manages bake, broil, timer, and self-clean functions
• Restores the control display and keypad responsiveness when the control is unresponsive or shows errors
• Helps correct ovens that fail to start or maintain temperature due to control failure
• Addresses intermittent or erratic oven operation linked to a faulty control board

• Turn off power to the appliance at the breaker before accessing or replacing the control
• Handle the control by its edges and avoid touching circuit components; wear anti-static protection if available
• Verify wiring placement matches original; take a photo before disconnecting connectors to ensure correct reassembly