General Electric Support Parts

This control base is the main console housing that holds and supports the oven/range control components, delivering a stable mounting surface for switches and the control board to keep controls aligned and protected during use. What it does:

• Provides the structural mounting for the range/oven control board and user interface
• Protects control electronics and wiring from heat, grease, and physical damage
• Keeps control switches, knobs, and displays properly positioned for reliable operation
• Helps reduce vibration and movement that can cause intermittent control faults

• One control base/console housing

• Disconnect power at the breaker before servicing to avoid electrical shock
• Handle control electronics carefully and avoid touching circuit contacts or components
• Some cosmetic trim or fasteners may need removal to access the control base; follow OEM disassembly steps

This holder element assembly secures the appliance's heating element in the correct position so the element stays stable for consistent operation and safe performance. It's a direct-fit replacement for worn or damaged holders. What it does:

• Secures and supports the heating element inside the appliance to maintain proper alignment
• Prevents element sagging or contact with other components that can cause noise or arcing
• Helps reduce vibration and movement that can lead to intermittent heating
• Common symptom: visible holder damage, loose or shifted element, unusual noise during operation

• Disconnect power (unplug or switch off breaker) before starting any repair
• Allow appliance and element to fully cool before handling
• Handle the element and holder carefully to avoid bending or damaging the element

Replaces a cracked or missing support rail cover trim piece on your refrigerator. Restores a finished look where the support rail meets the cabinet.

Replacement thermostat holder for your microwave. This mounting bracket secures the thermostat in place. Order a new one if yours is cracked or broken.

Reinforcement plate restores structural support where the oven door or trim attaches. Replaces cracked or broken plates to stop sagging and keep panels aligned.

Mounting plate assembly for over-the-range microwaves. Secures microwave to cabinet or wall brackets. Replace if cracked, warped, or damaged during installation.

Support base plate for electric and gas ranges. Mounts underneath to provide structural stability. Replace if cracked, broken, or missing for secure installation.

Secures and positions the heating element in your dishwasher. Replace if cracked, bent, or broken to restore proper element alignment and stability.

Sump plate that mounts at the bottom of the dishwasher tub assembly. Replace if cracked, warped, or damaged to restore proper structural support.

Support plate that secures the sensor board in your laundry center. Replace if cracked, broken, or missing to properly mount the control board assembly.

Self-leveling bracket for top-load washers. Mounts to the base to stabilize the unit. Replace if broken, bent, or missing to restore proper leveling.

White plastic door stop plate installs on refrigerator cabinet to support door closure. Replace if cracked, broken, or missing to restore proper fit.

Secures the defrost trough under the evaporator to guide melting water into the drain. Replace if cracked, broken, or missing to prevent water pooling.