General Electric Support Parts

Support plate for gas range burners. Mounts beneath burner assembly to provide stable base. Replace if cracked, warped, or missing to restore proper fit.

Left-hand broiler support plate for gas ranges. Secures the broiler assembly in place. Replace if cracked, warped, or no longer holding components firmly.

This plate side heater is the oven heating element that produces heat along the oven side to help maintain even cooking temperatures. Designed to restore proper heating when the side element is worn or failed. What it does:

• Heats the side area of the oven cavity to support even cooking and baking.
• Replaces a damaged or open side heating element that can cause weak or uneven oven heat.
• Helps address symptoms such as oven not reaching set temperature, uneven baking, or visible element damage.
• Works as a direct replacement when the original side plate heater fails.

• One plate side heater

• Disconnect power to the appliance at the breaker before starting any repair.
• Allow the oven to cool completely and use proper PPE when handling the element.
• Remove mounting screws and electrical connectors carefully; note wire locations for reinstallation.
• Reconnect securely and test the oven on a low heat setting to verify proper operation.

This latch plate assembly secures the dryer door and engages the door switch so the machine can run. It restores proper door closure and helps ensure the dryer starts and runs safely. What it does:

• Provides the metal strike for the door latch to catch and hold the door closed
• Engages the dryer door switch so the appliance recognizes a closed door
• Commonly used when the door won't stay closed, the dryer won't start, or the door strike is bent or worn
• Fits into the door frame and works with the latch mechanism to restore secure closure

• Disconnect power before installing to avoid shock or injury
• Removal typically requires opening the dryer door and replacing screws that hold the plate to the door frame
• Check the mating latch for wear and alignment; adjust as needed for smooth operation

Bearing plate for trash compactor ram assembly. Replaces cracked, worn, or broken plates that support the compactor mechanism. Structural component.

Spring support plate for dishwasher mounting systems. Replace this structural component if cracked, broken, or missing to restore proper spring tension.

Secures the dishwasher pump motor to the appliance frame. Replace if bracket is cracked, broken, or worn to restore motor stability and prevent vibration.

Mounting bracket that secures the drain pump in place inside your dishwasher. Replace if the original is cracked, broken, or missing to properly support the pump.

Secures dishwasher components in place. Replace this mounting plate if yours is cracked, broken, warped, or missing to properly support internal parts.

Bracket that secures the drain pump in place inside your dishwasher. Replace if the hanger is cracked, broken, or missing to properly mount the pump.

Support bracket that secures the heating element in place at the bottom of your dishwasher tub. Replace if cracked, broken, or no longer holding element.

Replacement sensor mounting plate for your dryer. Secures the sensor in position. Order a new plate if yours is cracked, broken, or missing.

Structural bracket that supports and secures the dryer motor in place. Replace if cracked, bent, or broken to properly mount the motor assembly.

Motor cradle support for washer dryer combo units. Securely mounts and stabilizes the motor assembly. Replace if cracked, broken, or worn to restore structural integrity.

Replacement diverter lever plate for your washer. This mounting plate secures the diverter mechanism. Order a new plate if yours is cracked or broken.

Front top mounting bracket for your washer. Secures the top panel to the cabinet frame. Replace if cracked, bent, or missing to restore stability.