General Electric Switch

Fix a dryer that won't heat or overheats with this heating element resistor assembly. Common solution for temperature regulation issues in electric dryers.

Fix a dryer that won't start or stop properly with this relay switch. Common fix for control issues. Moderate difficulty, typically 30-45 minutes.

Fix a washer that won't fill, overfills, or won't advance cycles with this pressure switch. Controls water level sensing and cycle progression.

Fix a washer that won't select the correct water temperature with this water temperature switch. Common issue when wash cycles use wrong temp settings.

Fix washer overfilling or underfilling issues with a new pressure switch. Controls water levels by sensing tub pressure. Moderate DIY repair.

Washer not filling or overfilling? A faulty pressure switch may be the cause. This switch monitors water levels to control fill cycles properly.

Washer not filling correctly or overfilling? This pressure switch controls water levels during wash cycles. A straightforward replacement part.

This capacitor helps start and run the appliance's motor, restoring reliable motor operation and improving performance. It's a direct-replacement electrical component intended to replace a failed or weak capacitor. What it does

• Provides the electrical charge needed to start and assist motor operation
• Helps maintain consistent motor speed and torque during run
• Commonly linked to symptoms like humming, motors that won't start, or intermittent operation
• Replacing a failing capacitor can stop repeated starter attempts and protect the motor from stress

• One capacitor

• Disconnect power to the appliance before servicing to avoid shock
• Discharge the capacitor before touching terminals; use insulated tools and follow safety procedures
• Note terminal locations and wiring before removal; replace with like-for-like connections

Fix an air conditioner that won't start or trips the breaker with this overload protector switch. Direct replacement part restores safe operation.

Fix an air conditioner that won't start or trips the breaker with this overload relay protector switch. Prevents compressor damage from overheating.

This is an overload protector that mounts on the compressor and shuts it off if it draws too much current or overheats. It prevents damage to the compressor motor by interrupting the electrical circuit during unsafe conditions. Replace this part if the compressor repeatedly shuts off and restarts, the unit fails to cool, or you hear clicking sounds as the compressor tries to start.